TGY AerodriveXp серии SK 28-36 750кВ / 262W

• Overall
• Quality
• Value

Certified Buyer Rated

Jun 15, 2011

Muito bom, com um spiner muito bom mesmo, recomendo

• Overall
• Quality
• Value

Customer Rated

Mar 07, 2011

I was going to use these in a boat, the Kv is good, drives a 40 mm brass prop with ease on 11.1 volts in a 1.3 metre patrol boat hull excellent scale speed. draws 14 amps on a Raboesch 40 mm 3 blade prop.

They are noisy, the bearings are gritty and the bell is not concentric with the shaft, i get 0.5mm run-out, this means lots of noise and vibration especially at a certain RPM which must be a resonant frequency.
I can live with the bearings they were easily replaced but the bell run-out is not good enough

Sorry Hobby King but this motor needs better quality control

• Overall
• Quality
• Value

Customer Rated

Oct 03, 2010

Don't waste your time and money on this one.

It is very noisy.

When I speed up the motor without load.

The noise out with vibration.

It is looks like unbalanced.

I test the motor using 12x6 propeller only 133wattA11x6 propeller 0nly 132watt.

It is not a 262 Watt motor look like.

So the performance is quite low.

• Overall
• Quality
• Value

Customer Rated

Sep 03, 2010

Sorry but have to give this only 2 stars. Yes the motor works but that's about it! You can't use 3S because you get virtually NO power out of it and if you go up to 4S to get anywhere near 200watts or more they start to get VERY hot after only a couple minutes. I was gonna use this in a twin setup P-38 but found other motors. I have other SK motors and they've been fine, just don't waste your time and money on this one.

• Overall
• Quality
• Value

Customer Rated

Apr 11, 2010

Parameters of winding resistance for this motor, are incorrect.

I have two.. They are exactly equal.

Measured resistance is 185 miliOhm.

Motor is "star" type.

It is quite useless for any higher power.

I may suggest, not to try to exceed 10 amperes.

You may use 4s or even higher voltage... Anyway, for 80 gram motor it seriously underperforms, and it will burn if prop is too big.

• Overall
• Quality
• Value

Customer Rated

Nov 04, 2009

This is perhaps the strangest motor I have ever used. I put it in an E-flite Mini Pulse with a 12X6 on 3s. It would barely fly it. When I tested other props on it, i had to go all the way to 14X7 to get adequate thrust. I ended up using 4s and 11X8 to get good performance.

• Overall
• Quality
• Value

Customer Rated

Oct 25, 2009

This is a good motor.Should be run on 4s for best performance.

• Overall
• Quality
• Value

Certified Buyer Rated

Oct 14, 2009

Good motor, but a bit too heavy, The price is good !

• Overall
• Quality
• Value

Certified Buyer Rated

Oct 05, 2009

tres bons moteur.moto planeur de0,9Kg.alloy folding spinner 50mm.pales 12/10.rhino 1750-3s.planeur monte a la verticale

• Overall
• Quality
• Value

Certified Buyer Rated

Sep 30, 2009

Indeed, wrote to avoid the review:

Engine bearings are not good, noisy operation.

Circuits mounted on the screws are long and meke, allen is now worn out.

Choose another engine waste of money.