Turnigy SK3 Aerodrive 2822-1740kv Brushless Походный Мотор

• Overall
• Quality
• Value

I got 6 flights

May 28, 2021

Great feel smooth operation quiet. got 6 flights with a 8x6 prop 850ma 3s battery 40A turnigy plush esc then it burned on startup of the next flight.

• Overall
• Quality
• Value

Really nice little motor

Feb 08, 2021

I have two of these on small electric launch gliders. Both run smoothly and quietly. Very well made motors.

• Overall
• Quality
• Value

Excellent motor

Jan 06, 2021

Bought this to test on a 'Foaminator'. Great running motor, plenty of punch, power with a 9 x 3.7 APC on a 3s, 1000mah LiPo. Wanted to find something with a shorter shaft. All good here.

• Overall
• Quality
• Value

SKU HK-30A

Sep 22, 2020

To pitty that the axle on the wrong side longer was. Luckely I could fix this. Most likely I ordered the wrong type. Very sad is the fact that these motors were not available for a long time. After the message that they were in thr warehouse again I ordered them immediatly. To bad that the motors were only available in China Wharehouse and not in UK or European Wharehouse. I ordered two of them and had to pay € 24 extra for taxes and handling fee.

• Overall
• Quality
• Value

Great little motor

Jan 21, 2020

This is my 4th and smallest SK3 motor. Mounted in a 1.5M electric sailplane, it is very smooth and reliably delivers the power. Very happy with it.

• Overall
• Quality
• Value

Very good quality

Dec 09, 2019

Super quality high performance lightweight motor . Used for glue-n-go series Mig 29 foamie, Blue Angel F4 and F-35, sk3 2822 1740 kV motor gives unlimited vertical. Have been looking for a good Eflite 340 replacement. Not cheap but seem to be holding up and performing well with apc 7-5 on 800 3-S.

• Overall
• Quality
• Value

Lightweight. Quiet and powerful.

Dec 03, 2019

So far have run motor for short bursts on 3s batteries and apc 7-5. Nice hardware with connectors installed and prop adapter. May have found a good substitute for the E-flite park 340. Will do more testing soon.

• Overall
• Quality
• Value

Unusable - can't losen rod screws

Jul 30, 2019

The rod is protruding from the wrong end.
I have a varied number of screw drivers that almost fit, but can not turn the rod screws.
Since I can't loosen the screws, I can't adjust the rod - so I can't use the motor.