Стабилизатор напряжения Turnigy RotorStar Dual Power 15A

• Overall
• Quality
• Value

Customer Rated

Jun 28, 2016

Unit defective. Could have caused a serious accident. Won't bother with an RMA because this only cost me $23.00. Weary of Rotor Star and Turnigy products, although the Turnigy servos i use have not failed yet. Spend your hard earned money on a Hobbywing 10A UBEC instead of this.

• Overall
• Quality
• Value

Certified Buyer Rated

Jul 19, 2015

kaliteli rn tavsiye ederim..

• Overall
• Quality
• Value

Customer Rated

Dec 24, 2013

I have this installed on my KDS 550, N680 HV servos on 6.8V setting and an Ebar plus AR6200 spectrum with satellite receiver and N690 on the 5.2v side. All seems OK but did burn out 2 N680HV with setup. The battery is a bit light for this unit but will upgrade it to higher discharge or just fit a few capacitors. Will post on further findings so far so good.

• Overall
• Quality
• Value

Customer Rated

Oct 21, 2013

I have fitted this on my hk550tt fbl heli easy setup keeps my align servos at a steady 6v fitting the low voltage alarm/led is a must this can save your heli, fantastic product from hobbyking.

• Overall
• Quality
• Value

Certified Buyer Rated

Jun 22, 2013

Hugh thing, that BEC, but as of now it works good. Feeded by a 3,3Ah nanotech lipo this a good powersupply for bigger helis.

• Overall
• Quality
• Value

Customer Rated

Mar 25, 2013

Some days ago i received my unit , i tried it on my TREX 600 nitro modified.Trex 600Nitro flybarless Head Vstabi .Very nice Voltage regulator, non problem for overheat or electric jamming with the Vstabi or the receiver Futaba 2,4 Ghz. Really a good product.

• Overall
• Quality
• Value

Customer Rated

Jan 30, 2013

Well what can I say... I have had a circa 6 flights (with plenty pitch pumping) with this and it seems great. Hopefully I am not speaking too early. On the work bench, if I do a lot of stick banging - pitch and tail, then the heat sink gets pretty hot! I hope this is not an issue. On the work bench there is no air flow, but then little resistance too. In the air you have the air flow to cool the heat sink and more resistance.

Now in fairness it only gets really hot when do plenty stick banging. Otherwise it remains just mildly warm when not going crazy on the tranny.

I am running a T-Rex 600N FBL 3 x DS610's and 1 x DS650 directly connected to the Rotorstar. Then connected to the receiver ports, is a Skookum SK540FBL with a DS620 connected to the Skookum for the throttle.

The pin flag works really well. I also have Spektrum telemetrics connected and it shows a steady 5.1v to the Skookum. I have not yet hooked it up to the servo ports as I need all four ports for the servos and no space for telemetrics.

All in all, this is great value for money compared to the GVR-7020. I just hope the quality is the same as the GVR-7020 and I don't lose my bird by by saving $60.