Turnigy Talon Tricopter (V1.0) - Расширенная углеродного волокна Boom (380мм) (3шт)

• Overall
• Quality
• Value

Certified Buyer Rated

May 20, 2015

I ordered these as spares that I might need someday. its for sure making talon tri looks bigger compared with the originals.parts quality seems good and the price was ok too. recommended for talon tricopter if you're putting huge motors and big props. with the stock arms I was able to put 14inch props and they're far enough not to show on fpv video, adding any bigger props and I think they'll show unless I changed the arms to the longer version.

• Overall
• Quality
• Value

Certified Buyer Rated

Jan 29, 2015

This makes the tricopter so BIG, even with 12 inch props

• Overall
• Quality
• Value

Certified Buyer Rated

Aug 02, 2014

Strong but have to grind down a Little to fit tri alu mount kit. but easy fix.

• Overall
• Quality
• Value

Customer Rated

Jan 18, 2014

High quality carbon rods.
As one of the guys said the frame mount side is really hard to get in so I had to sand it a little bit. The motor mount side though wouldn't stay in the motor mount without a coil of electrical tape around the rod.
In general I'm satisfied with this product but requires some inventiveness.

• Overall
• Quality
• Value

Certified Buyer Rated

Oct 30, 2013

Im using this to enlarge a turnigy talon hexa

• Overall
• Quality
• Value

Certified Buyer Rated

Sep 26, 2013

the talon sistem junction are too weak!

• Overall
• Quality
• Value

Certified Buyer Rated

May 31, 2013

Not much to say about these besides they are pretty high quality for the price, very stiff.

• Overall
• Quality
• Value

Certified Buyer Rated

May 27, 2013

These booms make the tricopter more stable.

• Overall
• Quality
• Value

Customer Rated

Nov 15, 2012

13.94mm-13.98mm O.D. These were VERY difficult to get in, make sure the slots are perfectly straight when you start them because after beating them into place with a rubber mallet you definitely aren't going to be turning them... Spread the blocks with the screw by putting the screw in the wrong way around and then put a piece of metal in the slot. When you tighten the screw it will wedge the slot open a bit more and let the arms in *a bit* easier. Basically it just makes it possible without breaking anything. The flex and twist more but that is because they are a lot longer. They make your Tri HUGE, you could put 30 inch props on it without interfering with anything! Actually with only 12" props it looks kinda silly. I'm running plush 40s, 35-36 NTMs on mine with either 11X4.7 for hovering or 12X6 for fast forward flight. I get about 20 mins of hover on turnigy 3s 5000mah battery and it handles the 8000 fine. (I got bored so I didn't fly a whole 8A batt yet).