Этот светодиодный PCB имеется зеленый СИД строба и непрерывный белый светодиод. Эти светодиоды ультра-яркий и легкий в использовании. Просто установите на печатной плате модели и подключить провод провод к источнику питания 3.3 ~ 5.5V DC. Особенности предварительно установленной JR штекер стиля для легкого "подключи и играй" совместимость с большинством стандартных приемников.
Источник питания: 3.3 ~ 5.5V DC
Потребление тока, ON режиме: 25mA
Потребление тока, OFF Режим: 1мА
ON / OFF управления: PWM, 1520uS
Цвета: зеленый / белый
Вес ( г )
Iv made two orders of this in green and red. First order works just fine. If you try to make the one led constant it burns out, so there not as good as the flytron's.
Second order they don't work. Leds look deformed ore like they melted. There's one flash apone power, but wont work more then that.
So i have to give them a 50/50.Produto defeituoso. Os leds no funcionam quando liga no tx. Parece um problema no circuito, pois os leds ligam quando ligamos direto.Very bright. Signal cable was not soldered in, but otherwise very good :)Great thought but I ordered two of these and they did not work the way it states in the website. Some investigation finds that there are two jumper pads to solder to keep an LED constant on however I've found my main control chip in the center to heat up MUCH more than normal if I bridge that solder gap.
That said, I'm going to keep both LEDs flashing to keep heat and power use down. Looks cool either way...Regarding the LED's behavior, you can choose which one blinks and which stays lit by bridging the jumper right next to the upper LED leg (if bridged, stays lit).
See files tab for pic.Both led are strobe, no solid white or red, as advertised, therefor only four stars.
Led are bright and good visible by nightfall.
You can turn led on and off by external channel on your transmitter.Just like to say as you can see in the pic , wire connections C G (control, Live , Ground) are incorrect for JR. Just need to reverse red and black wire in plug, use 3 pins, lift all 3 locks up and pull wires out of plug, reverse them - easy. Nice strobe and all bright. I have only powered (4.8v) them up without receiver so I expect the white wire will control function via TX.Just added these to my mqx quad, very bright LEDs I can't look at the white light for very long. I bought these for orientation on my quad I have one pulsing red on order, and judging by the brightest of the ones which I've installed I'm sure these are just what I was looking for. Probably about my 5th or 6th order from hk and I am both impressed with the items and the service which I have received.These LED lights are super bright!!!These are fantastic when i first plugged it into my receiver to test it, i was almost blinded by the white light and strobe, unbelievably bright...very nice i will get more