The Phoenix V2 2000 is a quick and easy to assemble electric powered glider with flaps and large ailerons for, precise and aerobatic performance. The EPO wings are fitted with a carbon spar for strength and 2 metal spars join the wings to the fuselage. Also, each aileron is reinforced with carbon to eliminate any chance of distortion or twisting. The wings are attached to the fuselage using fast connect clips, after flying, simply squeeze the clips to release the wings.

The lightweight, streamlined fuselage is blow-molded from a tough, rugged, and flexible plastic with plywood formers that will take a lot of punishment, it will bend and flex before breaking. The fuselage also includes a pre-installed main wheel which will protect the underside and provide smoother and easier landings. The EPO horizontal stabilizer and elevator are also reinforced with carbon to improve the strength and stop flutter when flying at high speeds. No glue is required when assembling, the vertical and horizontal stabilizer are simply screwed to the rear of the fuselage.

This is the 5 channel kit version which is not supplied with a motor, ESC, servos, or any electronics. Supplied is a complete airframe with motor mount, hinges, horns, screws, and folding propeller. The beauty of being the kit version is that you can choose which motor, ESC, and servos you wish to install. The Phoenix V2 2000 is an aerobatic "warm-liner" that flies and performs really well on a 200W or more 28mm motor, is strong, rugged, and very quick to assemble.

Features:
• A perfect sport and aerobatic electric glider
• Tough, rugged, blow-molded fuselage
• 2 wing spars and carbon reinforcement for strength
• Wings and tail are made from tough EPO
• Fast connect/disconnect clips for holding the wings to the fuselage
• Pre-installed main wheel for protection when landing
• Kit version allows you to choose which motor, ESC, and servos you install

Specs:
Wing Span: 2000mm (78.7")
Length: 1132mm (43.3")
Approx Flying Weight: 1000g depending on equipment chosen (no battery or receiver)

Included:
Volantex 759-02 Phoenix V2 2000 5CH Aerobatic Electric Glider (airframe only)
Horns and pushrods
10x6 Folding propeller

Required:
1500~2200mAh 3S 25C (or greater) LiPo Battery
6 Channel Transmitter and Receiver
28mm brushless motor of 150W or more
30~40A brushless ESC
4 x 9g nylon or metal-geared servos (6 required if using flaps)