Become a Dealer Blog
Register

Total Price

$0.00

Cart 0 Cart 0 Loading...

Turnigy Marine 180A BEC Waterproof Speed Controller with Water Cooling

Generating Links

Turnigy Marine 180A BEC Waterproof Speed Controller with Water Cooling

 
Price:

Now save save $0.00 $0.00

$107.93
Already Purchased Discontinued Product

Please continue searching for a similar product.
1 year warranty
SKU:
9020000034-0
want FREE shipping? Click here to find out more!

The Turnigy Marine waterproof speed controllers are packed with the latest technology and are up there amongst some of the best on the market today. These speed controllers have reached the ultimate IP67 level of protection (Ingress Protection), this is the standard that electronic devices are tested to. The 6 on the IP rating means it is "Totally protected against dust", the 7 on the IP rating means it is "Protected against immersion between 15cm and 1m.



The Turnigy Marine speed controllers are supplied with a "Copper Bar Heat Technology" water cooling system (exclusively patented) and extremely low internal resistance MOSFET's. Each one has specially designed software which features excellent start-up and acceleration performance, they have an outstanding amount of "punch" when coming out of turns when used in high speed boats. A waterproof on/off switch is fitted so that you can connect the battery then seal the hatch, the radio can then be switched on when you are ready to go.



2 running modes can be selected, either forwards only or forwards and reverse. The speed controllers also have multiple protections as shown in the features list below. Programming of the many features of the speed controller is easily done using your transmitter.

Note: "If you upgrade or have upgraded the firmware on the Marine / EZ-RUN / K-Force ESC, it will not work with the Programming card. You will only be able to do throttle calibration with the transmitter for the ESC and you will not be able to reset the ESC to factory settings".



Features:
• Patented water cooling system
• Excellent start-up and acceleration performance
• Bags of "punch" when accelerating out of turns
• Fitted with waterproof on/off switch
• 2 running modes can be selected (forwards only or forwards and reverse)
• Programmable via the transmitter
• Program modes: running mode, LiPoly cell count, low voltage cut-off, timing
• Overheating protection
• Low voltage cut-off protection
• Signal loss protection



Specs:
Voltage Input: 2~6 LiPoly cells (6~18 NiMh)
Continuous Current: 180A
Burst Current: 1080A
BEC Type: Switching with on/off switch
BEC Output: 6V@5A
Motor Connectors: 6mm
Servo lead: JR style
Servo Lead length: 300mm
Water Cooling Pipe: 3mm I/D~5.4mm O/D
Dimensions: 72x48x36.6mm
Weight: 245g



Please note: This speed controller is not supplied with a battery connector.

  • Miss Geico 29,ESC180A Turnigy, moteur Dynamite2000kv,Lipo2x3s 5,5A, INDRE ET LOIRE VALLEY
Upload video

Only registered users can upload video. Please, log in or register

Topics
Sort by
Most Recent Topics
* Nickname:

* Your Reply:


Please, enter the text shown in the image into the field below
*Verification Code:
Cancel
Submit
Post a new Topic
* Nickname:

* Your Topic:



Please, enter the text shown in the image into the field below
*Verification Code:
Post Topic

Only registered users can write reviews. Please, sign in or sign up

CENDRO | Verified Buyer

  • Overall
  • Quality
  • Value

Valeur sure

Apr 18, 2018

Fort, fiable ras ...

O. W. | Verified Buyer

  • Overall
  • Quality
  • Value

Good, but only 2 caps on the wires?

Nov 28, 2017

First impression is good. But... The esc has only 2 caps on the powerleads? On the pictures it looks like there are more on it. I have not installed it in my boat yet so can't give a proper review so far. Anyone else tried the version with the 2 big caps on the leads yet?

Zooma | Verified Buyer

  • Overall
  • Quality
  • Value

Looks Good.

Sep 13, 2017

My first impression when opening the box was that this is a very impressive looking bit of kit that comes with plenty of good reviews.
I bought this speedo for use in my Pursuit so it should be more than adequate and leave some "in reserve" that may be handy if I decide to upgrade the motor and/or cell count in the future.
The plugs that came on the motor that is fitted in the Pursuit were too small to fit those that are fitted to this speed controller but fortunately the speedo came with a spare set of 3 matching plugs (complete with colour coded heat shrink).
I removed the plugs from the motor and soldered-on the bigger ones - but then found that they did not fit into the speed controllers sockets!!!!
After about an hour of very careful sanding with fine emery cloth (and constant check fitting) I eventually had the plugs fitting smoothly (but tight) into the speed controllers sockets.
I now have everything fitted into my Pursuit and when connected up the speed controller worked immediately and the motor was turning in the correct direction - so all good so far.
The auto set-up was a surprise but I wanted to program the unit to make sure I had full throttle and to remove the reverse function.
So far the speed controller has refuse to accept any programming commands from the RadioLink transmitter so I will keep trying and maybe buy a programming card as I do want to get the best out of this speed controller and to make full use of its built-in functions.

peter | Verified Buyer

  • Overall
  • Quality
  • Value

8 out of 10

Jun 14, 2017

Seems to be working well but shuts down over 120 amps with green light flashing, doesnt feel too hot. Maybe the 180 amp rating is a bit optimistic?

Johan | Verified Buyer

  • Overall
  • Quality
  • Value

180

May 28, 2017

It is impossible to program this ecu with the transmitter, I can't enter the programming mode. When I run the boat it will only run for a couple of seconds before it shuts down and you have to go back to neutral position to start the engine again.

Rogier | Verified Buyer

  • Overall
  • Quality
  • Value

Marine 180A v3

May 10, 2017

I bought this ESC for my 820mm boat, it is very easy to install in the boat. (use super velcron) But to program it by using your transmitter a whole different ball game. I would def. recommend a programbox whit this ESC. Then you know for 100% sure your settings. I run it whit a 2200KV and it is like superfast. For the price their isn't any better for >800mm boats.

Rogier | Verified Buyer

  • Overall
  • Quality
  • Value

Marine 180A v3

May 10, 2017

I bought this ESC for my 820mm boat, it is very easy to install in the boat. (use super velcron) But to program it by using your transmitter a whole different ball game. I would def. recommend a programbox whit this ESC. Then you know for 100% sure your settings. I run it whit a 2200KV and it is like superfast. For the price their isn't any better for >800mm boats.

Daniel | Verified Buyer

  • Overall
  • Quality
  • Value

excellent product

Dec 12, 2016

easy to configure without a programming card
100% waterproof
a must have upgrade for any fast boat
get one.......

boboday | Verified Buyer

  • Overall
  • Quality
  • Value

Certified Buyer Rated

Jul 21, 2016

one of the best ESC for marine RC boats

Robin | Verified Buyer

  • Overall
  • Quality
  • Value

Customer Rated

Jan 10, 2016

This is the best ESC for boats over 800 mm. I have bought 5 because they are 100pcnt waterproof, tough, plenty of capacitors for long leads and have terrific punch. Don't hesitate - buy it.

  1. 1
  2. 2
Customer files
TGY Marine Manual Download [3044]
Firmware Download [472]
Upload your file

Only registered users can upload files.
Please log in or register to start helping your fellow hobbyists today!