Gesamtpreis

0,00 €

Warenkorb 0 Warenkorb 0 Loading...

Volantex 757-8 Ranger (PNF) Drückersegler 2000mm (78.7")

Generating Links

Volantex 757-8 Ranger (PNF) Drückersegler 2000mm (78.7")

Preis:

Now save speichern 0,00 € 0,00 €

135,86 €
Menge:
Versendet aus:
  • USA
  • Global
  • EU
Bereits gekauft
Voraussichtliche Ankunftszeit: Keine Voraussichtliche Ankunftszeit [ ? ]
Status:
Rückstand
SKU:
043000081-0
Kostenloser Versand? Klicke hier um mehr zu lernen!

Der Ranger 2000 ist einfach zu montieren und verfügt über eine große Flügelspannweite für Stabilität in der Luft. Die Flügel sind mit zwei Holmen ausgestattet, um die Flügel zu verstärken, und sie werden mit schnell verbindenden Flügelklammern befestigt, um die Flügel mit dem Rumpf zu verbinden. Drücken Sie nach dem Fliegen einfach die Clips zusammen, um die Flügel zu lösen und das Flugzeug problemlos in Ihrem Auto zu verstauen. Der Rumpf bietet Platz für eine FPV-Kamera und zugehörige Komponenten.


Das Plug-and-Fly-Flugzeug (PNF) ist ein Einkörperflugzeug mit einem Kunststoffrumpf, das bei Bruchlandungen einen flexiblen und leichten Schutz bietet. An der Vorderseite des Rumpfes können Sie durch ein vorgeschnittenes Loch eine FPV-Kamera hinzufügen. Die Position bringt Sie direkt auf den Pilotensitz, ohne dass Sie selbst in den stabilen Körper des Flugzeugs schneiden müssen.


Entfernen Sie das schwarze Verdeck, um ein Pritschenbett für die Montage verschiedener Kameras freizulegen, und verwandeln Sie Ihr Segelflugzeug in das perfekte FPV-Modell oder Videofahrzeug. Gleiten Sie mit diesem ERSTAUNLICHEN elektrisch angetriebenen Segelflugzeug durch die Luft, das sich perfekt für Wochenendflüge eignet.


Eigenschaften:
• PNF-Einkörperflugzeuge
• Optionale FPV-Kameramontage
• Klicken und Stecken Sie die Flügelclips, um die Montage zu beschleunigen
• Abnehmbarer Baldachin zur Montage verschiedener Kameras


Technische Daten:
Flügelspannweite: 2000mm
Sicherungslänge: 1100mm
Fluggewicht: 1083g (kein Akku und Empfänger)
ESC: 30A 2~4S
Motor: 2215 1400kV
Propeller: 8x4
Servos: 6x9g
Servokabel


Empfohlen:
1 x 2200mAh 3S 25C LiPo Akku
1 x 4~6 Kanal Sender und Empfänger

  • Spannweite (mm) 2000.00
  • Ranger Pusher Glider 2000mm Volantex RC PNF Maiden flight
Video hochladen

Registrieren Sie sich bitte, um Videos hochzuladen anmelden oder Registrieren

Themen
Sortieren nach
Neueste Themen
* Nickname:

* Deine Antwort:


Geben Sie den im Bild gezeigten Text in das Feld unten ein
*Verifizierungs-Schlüssel:
Abbrechen
Senden
Poste ein neues Thema
* Nickname:

* Dein Thema:



Geben Sie den im Bild gezeigten Text in das Feld unten ein
*Verifizierungs-Schlüssel:
Beitragsthema

Registrieren Sie sich bitte, um Bewertungen zu schreiben anmelden oder registrieren

mrl | Verifizierter Käufer

  • Quality
  • Overall
  • Value

Volantex ranger 2000

Jul 05, 2022

Très bon matériel facile à installer

giwiren | Verifizierter Käufer

  • Quality
  • Overall
  • Value

Ranger 2000 flies great

Mar 25, 2022

The Ranger2000 needs a good push on throwing but once going it flies great. The canopy was tricky getting it off the first time as it has small pegs that attach it and you need to pull outwards - starting at the rear corners is best.The plastic fuselage makes the plane very durable - asphalt does wear on it though even with smooth landings.

Nick | Verifizierter Käufer

  • Quality
  • Overall
  • Value

Volantex Ranger 2000mm

Mar 03, 2022

Good looking model let down by some quality issues. The canopy does not clip in at the sides. Had to be heated to get it to fit. Servos not secured properly either. Poor attention to important details otherwise ok. Fake wheel underside moulding should be an actual wheel. Would be more functional 4 sure. Check everything before you even attempt to setup to fly.

Pierre | Verifizierter Käufer

  • Quality
  • Overall
  • Value

Excellent product

Feb 12, 2022

The box arrived after being shipped through 4 airports on a strange routing by Fedex, everything was fine no damages, it was well packed, and well secured inside.
Assembly was simple, add the servo arms, links and control horns. I should mention here that the control horns were not the screw in variety mentioned in write ups, but had changed to a click in place type, which at first glance I wondered if they would be strong enough, I fitted a couple and did a pull test as much as I could and found that if I put anymore pull I would break the foam before the the horn gave way, so perfectly adequate for the job. Although I will mention that the legs that go through the foam were a little on the short side for the rudder which is much thicker than the others and required a lot of pressure to make the stop plate click into place.
The Servo's are nylon gears, metal are generally preferred these days, but since we used nylon back in the day without real issues, they were fine for me, and all were well installed and tested fine.
With a 2200mAh battery, a little weight is required to balance properly with the battery pushed as far into the nose as possible, a 3300 balanced the model spot on, however since I have a lot of 2200's I decided to go with those and use 2 at a time, which also works great and gives me longer flight times.
I maidened the plane on a slope, on a totally calm day, so had to fly with the prop running at between 40-50% all the time. I needed a couple of clicks of down, and one click of left aileron to set it up. I found that the ailerons were not very responsive at low speeds, better to use rudder control, I will adjust them for more up than down before going out again. This will be a mechanical adjustment rather than change out the Y leads, which will be simpler. At higher flight speeds there was plenty of aileron, so unless you want to do a bit of thermaling (which I did), there is no real need. This plane is virtually stall proof, it just drops the nose picks up some speed and levels off, no bad tendencies at all, it also doesn't tip stall at all, a very easy plane to fly all around.
I will mention here that a main concern for me is that where I live there are no grass areas to land and everthing is rubble or stony, so a big thing for me was the strong plastic fuselage, which after three flights with the first landing being heavy and not where I wanted at all on some very stony ground, the fuslage lived up to billing with hardly a scratch.
Overall a great model,is a very stable platform if you want to FPV, or if you want a first aileron glider to slope soar an excellent choice, or just for general messing about and versatility, good plug in system for the wings, dump it in the car, no messing with screws etc, just plug in the wings and fly!

Ranger | Verifizierter Käufer

  • Quality
  • Overall
  • Value

Gliding camera

Aug 12, 2021

This plane is easy to assemble without the need of glue. It has calm and rather slow flight characteristics and is a by that a very good camera platform. The ability to glide with the need of very little power offers a long flying time. The propeller thoug slows down the plane while gliding without power, a folding pusher prop made it much better. I`m using 3s 4000mAh lipos, the flying time with the help of thermals can be more than one hour up to endless, depending on how patient your neck is. Landing is easy with the four flap wings, can be done without flaps thoug. I'm very happy for what I received for that little money, I guess it is a good plane for beginners too.

sean | Verifizierter Käufer

  • Quality
  • Overall
  • Value

Volantex 757-8 Ranger

Jul 24, 2021

This model is awful compared to the smaller versions.
List of issues i had with the model:
1) Prop adapter is too large for the motor (lucky i had one that fitted)
2)Screws missing in the motor housing.
3)Tailplane retaining bracket had 2 out of the 4 mounts broken off.
4)Instructions out of date.
I just hope this flies...!!!!!!

MAXX65 | Verifizierter Käufer

  • Quality
  • Overall
  • Value

einfach Einfach

Jul 07, 2021

Wie bei allen HK-Fliegern ist auch dieser (PNF) einfach zu bauen und zu fliegen.
Viele Bauteile sind schon verbaut. (sollten aber immer auf Position und festen Sitz überprüft werden.)
Was mir bei diesem Modell gefiel, die Aufkleber (Design) waren nicht aufgeklebt, so hat man noch die Chance das Modell zu Colorieren. Hoffe meine Aussage kann helfen.

RodneyM | Verifizierter Käufer

  • Quality
  • Overall
  • Value

A nice floating, easy flying glider

Jun 23, 2021

The Ranger 2000mm is a nice easy to fly glider that floats on the thermals once you get the C.G. set, it tends to be a bit tail heavy with a 3s 2200mah. Launching from the ground(grass) is preferable than to hand launching and a breeze.

Ross | Verifizierter Käufer

  • Quality
  • Overall
  • Value

Superb aircraft!

Jun 19, 2021

This is my first glider/powered glider.
I'm impressed with it.
Landing it is a bit of a challenge as it glids for a long length before landing.
Nice aircraft and cheap for the size!

Doug | Verifizierter Käufer

  • Quality
  • Overall
  • Value

Volantex 757-8 Ranger (PNF) Pusher Glider 2000mm (78.7")

Jun 02, 2021

This model is POS !!!!! HARDWARE IS CRAP!!! DONT WASTE YOUR MONEY FOR THIS PLANE.

  1. 1
  2. 2
  3. 3
  4. 4
Kundendateien
Ranger 043000081-0-176343.pdf Download [3]
Datei hochladen

Registrieren Sie sich, um Dateien hochzuladen.
Bitte anmelden oder registrieren um jetzt Hobbyisten zu helfen!

Related Tags

Zubehör