5008-340KV Turnigy Multistar Multi-Rotor Motor With 3.5mm Bullet Connector Installed
5008-340KV Turnigy Multistar Multi-Rotor Motor With 3.5mm Bullet Connector Installed
Copy and Share the Below URL
Looking for the ultimate power system for your next Multi-rotor project? Look no further!
The Turnigy Multistar outrunners are designed with one thing in mind - maximizing Multi-rotor performance! They feature high-end 45SH magnets, high quality NMB bearings and High Poles counts for less noise, smooth and responsive power and increased efficiency. They have custom motor mounting and all are precision balanced for smooth running, these motors are engineered specifically for multi-rotor use and are not based on airplane motors.
The 5008-340KV MultiStar is almost too nice to fly! The workmanship and detail in this motor is at a whole new level. It’s fitted with shimmed and pre-loaded NMB bearings and high grade silicon wires. It has dual prop mounting, either a bolt on 6mm shaft prop hub or the 12mm spacing bolt threw prop attachment with a precision upper thrust washer for an unlimited range of props. And with 12P14S pole count its smooth efficient and has loads of torque.
Multistar is simplifying the world of Multi-Rotors with their purpose built product line and taking the guess work out of your setup.
Specs:
KV(RPM/V): 340
Lipo cells: 4-6s
Max Power: 700w
Max Amps: 40A
No Load Current: 0.7A/10v
Internal Resistance: .130ohm
Number of Poles: 12P14S (12poles 14 stators)
Dimensions(Dia.xL):59 x 28mm
Motor Shaft: 4mm
Prop shaft: 12mm hole to hole for bolt through style props
Weight: 163g
Bolt hole spacing: 19mm * 25mm
-
Kv(rpm/v) 340.00
-
Max Current (Motor) (A) 40.00
-
Resistance (mh) 0.00
-
Max Voltage (V) 22.00
-
Power (W) 700.00
-
Shaft A(mm) 4.00
-
Length B (mm) 28.00
-
Can Diameter C(mm) 59.00
-
Can Length D(mm) 12.00
-
Total Length E(mm) 28.00
