Eliminating the vibration to the flight controller on multi-copters is extremely important. All flight controllers have accelerometers built into the board that are sensitive to vibration. Advanced flight controllers combine the data from these accelerometers with barometer and GPS data to calculate an estimate of its position. This position estimate is critical when in altitude hold, loiter, return to home etc, excessive vibration can throw off the estimated position and cause problems like flying off or jumpy flight.
This damping platform is cleverly designed to reduce vibration to an absolute minimum and will ensure smooth and trouble free flight of your mult-copter. The damper rubbers are angled at approx 45° which greatly improves the ability to absorb vibration and keep the top platform steady. Supplied with rubber dampers, mounting screws and double sided sticky pads.
Bottom Plate Dimensions: 95x55x10mm
Top Plate Dimensions: 84x44x8mm
Distance Between Top and Bottom Plate: 17mm
I bought this for my pixracer FC and AlienCopter Bee frame, but wasn't able to use it because it is WAY too big. Can't fit it even in this 430mm frame!very nice but little bit big mount in quad. had to fix in small room, i have to made custom mount but i used only damping balls from thisThis product is a useful product which can reduce vibration when the fixing to the frame FC.
Also good price.semplice ma efficace riduce notevolmente le microvibrazioni controllato sul log con mission plannerMounted on top of my FW 450 Quad and mounted my HK Pilot Mega 2.7 flight controller on top. Pretty good fit. Nice vibration reduction accessory at a good price.Great vibration isolation platform for an APM flight controller. Mounting holes did not match my Flame Wheel but used double sticky and cable ties for solid installation. No vibration evident .I use it to mount a camera on it. Works great for that.a little flimsy on the material. Nonetheless good enough.Very well made. Could probably use softer dampers but it works anyway.a must for APM enthusiasts, 3d printed my earlier version, before this came along