If you’re looking for outstanding performance in a tiny package, The Multistar 4-in-1 ESC is the perfect solution. The multistar 4 x 35amp ESC is a single PCB containing four 35amp BLHeli-S equipped ESCs in a 35 gram package.
These ESC's have superior performance and utilize hardware generated motor pwm for smooth throttle response. Another feature of these ESC's is Oneshot125 which is a faster communication protocol between the flight controller and the ESC on your multirotor. It allows the flight controller to send commands to the motor quicker allowing faster acceleration, regenerative braking and active freewheeling.
The BLHeli-S Rev 16 has masses of programming parameters that can be easily programmed from your transmitter or using the MultiStar programming card. The ESC signal input plug is a 6pin SH1.0 connector for easy connection to most low profile boards. Alternatively, use the included SH1.0 to 2.54mm DuPont breakout cable to connect to your standard servo pin headers.
MultiStar BLHeli-S ESC's are the latest generation of speed controllers designed specifically for multirotors (drones). They are super simple to install and very easy to set up.
• 4 in 1 BLHeli-S equipped ESC
• Compact and lightweight weighing only 35g!
• S code for superior performance
• Smooth and linear control
• Oneshot125 for rapid throttle response
• Regenerative braking
• Active freewheeling
• Beacon functionality
• Stalled motor protection
• Throttle signal loss protection
• Safe power-on (throttle lockout)
• Thermal protection
• Startup power
• Commutation timing
• Demag compensation
• Rotation direction
• Beep strength
• Beacon strength
• Beacon delay
• Throttle range
• Thermal protection
• Low RPM power protection
• LED control
Continuous Current: 35A
Cells: 2S to 4S
Voltage: 7.4v to 14.8v
1 x 4 in 1 ESC
1 x Mounting spacer kit
1 x cable connection set
Easy to fit (once you've got the heat shrink off) works a treat. Use the signal layouts on the stickers provided not images on the internet (s1-s4 were the reverse order to the picture above). Could do with one or two more videos online for this one to give people confidence in fitting and configuring it. My first BLHeli-S buid otherwise I might have made one myself.This 4in1 is great for tidy builds ... has a lot of power, compared with the 4in1 LittleBee 20A its just a tad bigger.
I had to cut the shrinked plastic around the holes away but thats no biggie.
Holds up nice so far! It`s a Little bit too expensive ... if this would cost 5$ less i imagine a lot more people would buy it.