The servo designed for racing only, due to racing tough competition make servo hot even over use, the upgrade assist parts are heat sink settle down motor overuse. With a servo accessory package and is made with a heavy duty servo case, the servo is designed for R/C high performance Car applications. Double ball bearing with flexible rubber waterproof, otherwise the output spline is same with Futaba 25 tooth.This servo comes with JR/Hitec S Connector also known as a "Universal Connector". Even thought this servo comes with JR/Hitec S Connectors, this servo is electrically compatible with Futaba receivers.Features:• Metal gear
• Curve gear with smooth.
• Double M9.6 ball bearing (si-oil)
• 3 pole strong torque of motor with low signal affect and success get CE certification.
• Rubber fitting case for waterproof
• Same with Futaba 25 tooth spline
• Heavy duty servo case
• Middle of heat sink
Weight: 51.3 grams / 1.84 oz
Dimensions: 40.5 x 20 x 42.5 mm / 1.60 x 0.78 x 1.64 inch
Torque: 4.8V: 12.6kg-cm , 181 oz-in
Torque: 6.0V: 14.2kg-cm , 195 oz
Speed: 4.8V: 0.20 sec / 60° at no load
Speed: 6.0V: 0.17 sec / 60° at no loadSpline Count: 25
Unit Weight (g):
ok memnunum servodan.ok gl ve torku yksek.Traxxas revo off road aracimda kullaniyorum ok memnunum mkemmel.Nao testei ainda, mas tem um otimo acabamento. A embalegem e os encaixes dos servos sao reforcados.
Very happy about this servo, I use in a cameramount for precise movements, its rock solid and have no center play, I would buy it again.I had to change my opinion on this servo. It is very strong and perfectly working BUT those two I had are dead now. There is some problem with electronic because both burned. One was working well for approximatelly 2h run time in my FG and the second died on steerind in my Venom Creeper after one hour. Either I am bad lucker or this type is only rubbish.One say undershoot, another say oveshoot, I say OK. I use it for trhrottle/brake in my 1/6 FG monster on 5cell pack. The servo is strong enough to brake well, speed is also good. I am hobby driver and this servo is better than I needed. Before this I used HX12k but it was unstable in center and not able to handle work for a long time on 6V.
I suggest this for all drivers who need a strong servo for brakes.This BMS-660MG+HS Super Strong Servo is not all that good.
The servo overshoots and uses a long time to center. It is a strong servo but I doubt the 12.6kg spec in comparison to other servos with the same spec. Of course for the price the servo is not all that bad. It does ok in a savage x.
Really nice servo, very well built, excellent accessories, only minor gripe is the tiniest bit of undershoot in operation, degree or two but doesnt affect centring. Dont think it will affect a sports model. If you need faster operation go for the digital versions of the bluebird range