The servo designed for racing only, due to racing tough competition make servo hot even over use, the upgrade assist parts are heat sink settle down motor overuse. With a servo accessory package and is made with a heavy duty servo case, the servo is designed for R/C high performance Car applications. Double ball bearing with flexible rubber waterproof, otherwise the output spline is same with Futaba 25 tooth.This servo comes with JR/Hitec S Connector also known as a "Universal Connector". Even thought this servo comes with JR/Hitec S Connectors, this servo is electrically compatible with Futaba receivers.Features:• Metal gear
• Curve gear with smooth.
• Double M9.6 ball bearing (si-oil)
• 3 pole strong torque of motor with low signal affect and success get CE certification.
• Rubber fitting case for waterproof
• Same with Futaba 25 tooth spline
• Heavy duty servo case
• Middle of heat sink
Weight: 46.5 grams / 1.66 oz
Dimensions: 40.5 x 20 x 38.5 mm / 1.60 x 0.78 x 1.54 inch
Torque: 4.8V: 5.3kg-cm , 76 oz-in
Torque: 6.0V: 6.4kg-cm , 89 oz-in
Speed: 4.8V: 0.10 sec / 60° at no load
Speed: 6.0V: 0.08 sec / 60° at no loadSpline Count: 25
Unit Weight (g):
Top Quality servos. Happy with them so far. Only thing is, I glued the cables on the board just to be save no cable comes loose in time. But I do this with all servos if not factory done. This servo ist fast, good centering and has a nice housing as it is a bit transparent. Never seen this before. If it is reliable we will see in future after exessive using,I have two of these servos, one in my HPI Sprint 2 drift car and another in my HPI SPrint 2 touring car. Work really well, bolt straight in. Comes with mounting screws also which is nice. Packaged very neatly in a plastic case with foam insulation Well worth the money. Thanks HobbykingThis is an amazing cheap and very fast servo for 1/10 drift car. Ive had this on my yokomo countersteer car for a couple months now and its still going strong. Buy it...Suficientemente rapido para un buen control en una auto de drift 1/10. Funciona mucho mejor con un BEC a 6 volt para su maximo rendimiento.Good servo for a good price.Very smooth, very quiet, nice servo. Great value.GREAT SERVO STRONG AND TOUGH ...WELL WORTH THE BUYWorks always. Just to buy itI have 2 of it, very fast, measured values: 0,07 sec/60 deg and 0,05 sec/60 deg. For 1/10 4WD touring car or 4WD buggy strong enough.I used it in my HK600 @5,5V with the GA-250 Gyro set to 1520 s / 250 Hz.
The Servo is getting pretty warm after very smooth and slow flying. No 3D or something. I don't realy trust in this servo as its getting a lot warmer then my Align DS20 @ 333Hz in the same setup.