CNC Alloy Throttle Arm for Gas Engines

• Overall
• Quality
• Value

Works well and well made

Jun 28, 2019

Well made and works as it should also they hard to get hold of

• Overall
• Quality
• Value

Certified Buyer Rated

Dec 17, 2014

Muy util y barato....

• Overall
• Quality
• Value

Customer Rated

Jul 15, 2013

I have used several of these on Walbro carbs to solve a common problem involving clearance and positioning of the throttle arm on my gas powered planes. Perfect fit with extended housing and arm make life hooking up the throttle much easier. I recommend them.

• Overall
• Quality
• Value

Customer Rated

Mar 28, 2013

Perfect. These arms work great with almost ANY Walboro carbed engine.



Remove the existing screw, pry off the old short arm, and insert this one. Tighten down the berg screw and you're done.



You can install a ball socket screw for a freely moving throttle linkage setup.

• Overall
• Quality
• Value

Certified Buyer Rated

Feb 02, 2013

Very impressed with arm, appears chrome plated, very attractive. Fits on my RCG26 and DLE30 easily. Specs are as follows: ID is abt 4.8mm as fits throttle shaft of 4.75mm snugly, OD is 9.5mm/.375", overall HT is 18.5mm/.731", Center shaft to 2mm linkage hole is 17.35mm/.731", overall width is 25.1mm/.99". Uses a 3mX3m set screw requiring a 1.5mm hex driver. These measurements are as accurate as I could obtain using electronic caliper. I will order additional arms for other engines. Hope this helps those needing dimensions. Would work on chokes with same diameter shafts.

• Overall
• Quality
• Value

Certified Buyer Rated

Sep 21, 2012

Very good arm for gas engines.

• Overall
• Quality
• Value

Certified Buyer Rated

Aug 10, 2012

Excellent solution to an often overlooked problem. Fits, works and alieviates problems with the choke rod fouling the throttle rod

• Overall
• Quality
• Value

Certified Buyer Rated

Jun 26, 2012

fiyatna gre ok kaliteli bir rn...