The CORONA 2.4GHz R6FA-SB Spread Spectrum FASST Compatible Receiver is designed for use with FUTABA’s FASST 2.4GHz transmitters; including the 3PM, 3PKS, 3VCS, 3GR, 4PK(S), TM7, TM8, TM10, TM14 and the T6EX-2.4G, 7C-2.4G, 8FG, 10CG, 12FG. The R6FA-SB receiver supplies a more useful mode for users. The R6FA-SB supports not only FUTABA’s FASST air system, but FASST surface systems as well. This receiver supports up to 7-channels with continuous PPM (positive and negative) output, RSSI output and S.BUS output. It also
supports 6 channel high speed PPM(HS) mode to optimize helicopter response control and S.BUS output.
Under S.BUS output mode, R6FA-SB supplies 12 proportional channels and 2 DG channels. Therefore, the R6FA-SB becomes a 14-channel receiver when using S.BUS output.
Operating Current: 50mA max
Operating Voltage: 3.6 ~10V
7mS for independent 6 channel (HS) output@ FASST multi-channel mode
14mS for independent 7 channel (LS) output and S.BUS output @ FASST multi-channel mode
8ms for independent 6 channel (HS) output@ FASST 7ch mode
16mS for independent 7 channel (LS) output and S.BUS output @ FASST 7ch mode
14ms for independent 3 channel output@ FASST surface system C1 CODE mode
Sensitivity: about -100dBm
Operation temperature: -10~80 deg C
Last week I ordered 2 of these receivers and is working very good with my Futaba T10CG (the one with the module in the TX , and the big antenna option).
That's a big difference in price (original Futaba R617FS receivers)! And the quality is the same!
Cor Hofstee,The NetherlandsFutaba transmitter must be a compatible receiver fits in.
One more order.
I replace the receiver adjusts the helicopterT14SG is also compatible with the S-Bus well being compatible with the transmitter.
Must be a good listener, use the two purchases of Anaheim.oi pessoal, eu estou usando este rx em um drone, mas no consegui habilitar o fail safe, meu radio um futaba 14 fg, alguem conseguiu usar esta funo.
Avoid the high prices of expensive futaba receivers, use a corona with a quality excelete.good reciver fast to bind whit my futaba 14 use it on my 3d epp yak
make 10 flight all is ok no problem!!!Using this on a DJI F 450 in S-BUS mode with success.
It's small, lightweight and cheap.
I will buy it again!one thing for sure, is the plastic case looks so much better than frsky.
Can any one give review for this one ?