Get more out of your Durafly PNF set-up with the Durafly ESC programing card. This new card is compatible with all Blue Durafly ESC's and allows you to change a huge range of settings and features very easily and with minimal fuss.
Simply remove the prop from your Durafly PNF model, plug your Blue Durafly ESC into the card, move the jumper plugs to your desired settings and then just plug in your lipo to the ESC. You'll hear a single beep, and that's it, you've just programmed your ESC.
The Durafly programming card is an extremely useful tool and fits right into your pocket or transmitter case. Great for setting up your Durafly PnF model on the bench, or for experimenting with your set-up at the field.
• Battery type: Lipo or Nimh
• Motor timing: Automatic/Low/High
• Active RPM control (Heli Governor mode)
• Motor Rotation: Forward/Reverse
• Start Up Modes: Very Soft/Soft Acceleration/Start Acceleration
• Low Voltage Cutoff: Low/Medium/High
• Brake: On/Off
• Power either via the ESC or external 5V supply
Input power: 4.8-6V
Size(L x W x H): 55mm x 42.5mm x 3.5mm
For a full and in dept explanation of all programmable features and instructions on how to use this production. Please see the manual under the 'files' tab below.
The Durafly ESC programing card is only compatible with our newer 'Blue' Durafly ESC's (see picture above). You will find these in the Retro Series UglyStik and the EFX Racer and all new Durafly releases from 2015 onwards.
This card works with the durafly, aerostar and hobbyking esc's. It's much better than using the programming tree and listening for and counting the beeps of insanity!same as aerostar. U can use instead of aerostar as well....Essential to easily configure ESC. Bought so I could re-use the one that comes with the Komet! Against my expectations not needed to use yet!