GT450PRO Tail Holder (Belt Version)

• Overall
• Quality
• Value

Certified Buyer Rated

Mar 09, 2016

muy til, solo que le falta incluir el resto de la parte, donde van acopladas las palas del rotor de cola

• Overall
• Quality
• Value

Certified Buyer Rated

Dec 28, 2013

I really cant comment. I received the wrong one wanted this one but got the TT version.

• Overall
• Quality
• Value

Certified Buyer Rated

Apr 27, 2013

Great quality. works great also for the HK450pro - reassabling from torque tube to belt drive.

• Overall
• Quality
• Value

Certified Buyer Rated

Mar 13, 2012

Nice replacement for the Pro tail holder. Bent units never seem to work perfectly again so this is cheap enough to just replace the unit instead of trying to piece together the old one.

• Overall
• Quality
• Value

Certified Buyer Rated

Jan 10, 2012

En transmision por correa! considero el mejor holder de cola 450!saludos

• Overall
• Quality
• Value

Customer Rated

Dec 23, 2011

Purchased this to replace a flimsy eBay aluminum tail that just happened to crack as I was spooling up my KDS450S

These are built very solid with perfect tolerance for the bearings and shaft. With the eBay one, if I tightened the screws, the bearings would bind.

The only issue I had is that the set pin for the boom wouldn't go in all the way. I could have drilled out the hole a bit bigger but by tightening the screws for the tail fin, the tail is solid tight on the boom. Would buy again.

• Overall
• Quality
• Value

Certified Buyer Rated

Oct 23, 2011

Tak toto je uz ina vecicka,to sa mi rozhodne paci a som za aby sa to naskladnovalo aj nadalej.Ved o tom vsetkom to zasa je.Je to pre nas vsetkych.Aj

• Overall
• Quality
• Value

Customer Rated

Oct 23, 2011

Excellent metal tail for my EX-I450 belt drive. I replaced the M2x16 hex bolts which hold the metal tail assembly to the boom with longer M2x20 hex bolts and nylon insert lock nuts. Of course I had to drill out the old threads to accommodate the longer hex bolts. now I have a solid setup.
Luck,
Vince

• Overall
• Quality
• Value

Certified Buyer Rated

Jul 09, 2011

Great fit, good replacement after minor accident.

• Overall
• Quality
• Value

Certified Buyer Rated

Jun 25, 2011

Nice crafted, and good quality BUT: Had to buy an additional unit when the screws (both) holding the holder to the boom snapped inside. The screws is therefore recommended to change BEFORE first time use. Be aware.