GWS EP Propeller (RD-8043 203x109mm) black (6pcs/set)

• Overall
• Quality
• Value

Customer Rated

Jul 20, 2015

Very poor props, Thought they'll be good having the GWS name but appeared to be not. They are very flexible and cant lift the plane, I used it on Ft-22 with 1100Kv motor powered by 3S battery, it was noisy, flexed alot till it broke in midair, and didnt lift at all.
Might be useful to fly lighter planes with slower motor.
Compared to other type props, a bit expensive.

• Overall
• Quality
• Value

Certified Buyer Rated

Jul 07, 2014

Vrai GWS dont la rputation n'est plus faire!

• Overall
• Quality
• Value

Customer Rated

May 10, 2014

Buyers please be aware that these props WILL NOT fit on the Turnigy 2204/14 motor. That is mostly used for indoor foamies. These props come with adapters but none are big enough to fit on this size motor. Very disapointing as the old gws 8x4.3 used too!!

• Overall
• Quality
• Value

Certified Buyer Rated

Sep 13, 2013

Very poor prop.

Can not fully power My reaktor 3d plane.

• Overall
• Quality
• Value

Customer Rated

Jul 31, 2013

Perfect for piaget with the prop saver, you need to use the other side of the prop saver. (One side is fine with RD old GWS and one side is fine for DD prop and these new RD GWS).
If you are able to run DD prop like GWS 8040 you will be able to run this prop without adaptater.

• Overall
• Quality
• Value

Customer Rated

Jul 30, 2013

These props shall be replacing the previous GWS props, but they can NOT!!! These props dont fit on the TURNIGY 2204-14T 19g Outrunner (the most used indoor motor in our club). Also the contained adapters dont fit on the motor, so you have to install an adapter and have to drill it to the required diameter.

Diese Propeller sollen angeblich die vorherigen GWS Propeller ersetzen, aber das tun sie nicht. Sie passen nicht auf den TURNIGY 2204-14T 19g Outrunner Motor, welcher der ist, den wir in unserem Club am hufigsten einsetzen. Die beigefgten Adapter passen ebenfalls nicht auf den Motor. Man muss also einen beliebigen Adapter einsetzen und ihn anschlieend auf das bentigte Ma aufbohren.