Designed for planes only, the H-KING esc's are an excellent choice for any plane requiring linear, sharp and reliable throttle response on a 35A esc.H-KING speed controllers have strict end-of-line QC testing and are SMT (Pick-n-Place) in the same room as the through-hole soldering(wires, capacitor) and packaging is done. Improving quality and reducing contamination and inconsistencies due to transportation.
The H-KING 35A includes an XT-60 and 3.5mm gold plugs pre-soldered, plus to make it even easier it comes pre set-up with LiPo settings and Auto cell detection.
The H-KING Speed Controller includes a 2A BEC (Battery Elminator Circuit) to power your receiver, there is no need to have a seperate receiver battery.
The H-KING range of ESC's are both economic and reliable, plus they don't need any setup or soldering. Just plug it in and fly!
Amp rating: 35A
Burst Rate (15sec): 42A
BEC Current: 2A, 5V (Linear)
Voltage: (2-4 cell Lipo)
Can only confirm what most of the others wrote. ESC continously beeping after connected to prog card... no way to reset it. At least I have not found one.
That one is going into the bin. what a waste of time and money :(On the bright side, This ESC worked right out of the box with my AR6400 receiver, after the problem below happened, the replacement Castle ESC gave me a voltage lockout. (So kudos there, no need to be re-flashed) On the darker side, Solder Joints are week, and the receiver leads started coming loose after just one flight. That whole area is covered in glue, so a re-solder was not possible. I just chucked the components, and harvested the wires for other projects in the end.This is my favorite ESC. While the wires are a little small, It works.Once again Hobby King delivers outstanding product at an outstanding price. My favorite part about this speed controller is that the instructions they include for programming (provided the factory settings are not correct) are actually very easy to follow and very clear.Nice controller, put it in a radjet 800 works well on a 3s 2200mahThis series of esc have proven to me to be as reliable as others costing 2 to 3 times more. I wish HK made a 70 and 100 amp. as well.Great esc have been using these in park fly stuff and Tek sumo for over a year and all perform faultlessly and there a great price.Un controleur de qualit suprieure,fonctionne trs bien,complet .I have flown with this is ESC so many times, I've lost count. I'm pulling 25 amps with my HK Walrus glider and the ESC's performance is rock solid. After 20 - 30 minutes of flight with some vertical climb runs for 10 seconds, it's warm to the touch.
I wouldn't recommend for anything over 30 amps. Lower than that you're good to go.Sorry to say but this is a bad product!
I just programmed the brake and it won't stop beeping.
No reset options, no factory defaults.
Can't claim warranty because I needed to change the battery connector to fit my battery. So browse away from this product while you can!
This product is a waste of your money.