Register

Product Finder

Settings

Useful links

Live Chat
 
[["US","AU","GB","DE"]]
Register

"Hard One" 0.7M Hardened Helicopter Pinion Gear 6mm Shaft - 10T

"Hard One" 0.7M Hardened Helicopter Pinion Gear 6mm Shaft - 10T

Discontinued Product

Please continue searching for a similar product.
Rating:
Stock:
OUT OF STOCK
Weight:
21 g
SKU:
414000043
Product
Description

"Hard One" 0.7M Hardened Helicopter Pinion Gear 6mm Shaft - 10T

Not all Pinions are Created Equal!

"Hard One" Pinions are the last pinion gears you will ever need. They are machined from a special steel alloy and hardened for ultimate strength and durability. During the manufacturing process, extremely tight tolerances are maintained so the pitch of the gear is precise. This means "Hard One" gears run very quietly and efficiently.

As Brass or Aluminum gears wear the interface between the pinion and spur gears degrade. You can see this as sharp pointed teeth on pinion and spur gears. The wear can also be heard as a grating sound while your helicopter is flying.

"Hard One" Pinions are so tough that they can be eliminated as a potential wear point. They can actually make your spur gears last longer! They are also strong enough to survive any insane power system that you can fit in your helicopter.

Note:
If you have a Neu Motor - Neu motor shafts are .05mm over size. The solution to this is to run the motor at low rpm and touch a piece of 400 grit sand paper against the shaft for a couple of seconds. Then the pinions fit perfectly.

Product
Specifications

Additional Information

  • SKU:
    414000043
  • Brand:
    N/A
  • Capacity (mAh)
    No
  • Shipping Weight(g)
    21.00
  • Length:
    90.00
  • Width:
    20.00
  • Height
    50.00
Community
Discussions
Rate&
Review

Write Your Own Review

Only registered users can write reviews. Please, sign in or sign up

verified_user Quality
trending_up Value
playlist_add_check Overall
I have bought several of these pinions.
The first pinion tested immediately took me a destroyed main gear.
The edges of the teeth are not properly deburred.
After I edited the pinion it works.
The quality control should normally see this.
So, before the installation, the pinion deburring !!!
verified_user Quality
trending_up Value
playlist_add_check Overall
Upload
Videos
Upload video
Upload
Files

Only registered users can upload files. Please log in or register to start helping your fellow hobbyists today!

Product Tags

Use spaces to separate tags. Use single quotes (') for phrases.