The new Flip 230 is a super light and durable 230mm FPV carving machine. The Mainframe consist of the lightened 1mm G10 with built in PDB with aluminum standoff making for a super light and stiff center frame. There are LED mount points on the front and rear for orientation and are tied to the PDB for wiring easy. The motor arms are a beefy 3mm thick for durability from abuse the little racers get. There is a forward mounted camera support and the whole frame weighs a mere 115g. The Flip is light and durable fpv carving machine.
• Super lightweight
• Integrated PDB for a minimal wiring install
• Thick 3mm arms for durability
• Powered LED provisions for orientation
Motor Mounting: 12,16,19mm
Very light frame easy to set up quick and easy build frame. ideal for a 250 size. robustness is slightly week. However value for money.Very lightweight Frame with alot of Space. When you get the cage plates, they do feel pretty thin and flexible, but once assembled the frame is quite stiff. Havent had any bad crashes yet, rough landings are no problems though and the arms feel quite strong.
I put the escs on the inside by using the opposite powerpads of the distributionboard for each esc, so two Esc are overlapping. Still plenty of space for fc, fpv cam, vtx and rx. I put the battery on top.
There is plenty of (long!) screws for the spacers.
If you dont care about clean dirty frame and just want cheap lightweight frame, its really good!