JR NX8921 Wide Voltage Programmable Ultra High Torque Metal Geared Servo 36.5kg / 0.13sec / 72g
JR NX8921 Wide Voltage Programmable Ultra High Torque Metal Geared Servo 36.5kg / 0.13sec / 72g
Awesome!
Copy and Share the Below URL
We are pleased to be stocking JR Propo's XBus NX series servos, allowing not only serial servo connection, but also individual servo programming with servo adjustments to suit every application
The NX range of servos automatically detect the type of output they are plugged into, conventional receiver PWM outputs, or XBus. This means NX series servos are XBus compatible, and also compatible with PWM receiver signals without any converter, allowing modelers to use conventional receiver systems.
Compatible receiver systems: DMSS/DSM2/35MHz/40MHz
When used on a JR XBus system, the NX series servos can be programmed in ways not previously possible. No additional programming device is necessary these servos can be setup using a JR XG series transmitter.
Changes made to servo programming are immediately apparent. Not only can servo direction and travel be adjusted, but it is now possible to fine tune servo holding power, stopping speed, deadband, starting power, total servo travel and slow start to suit your aircraft and desired response, you can even set an alarm if the servo exceeds the user set limits. This precise setup allows servo hunting to be eliminated and precise feel maintained.
This servo features an upgraded heatsink center case to improve cooling. If you are looking to take the performance of your model to unprecedented levels then the JR NX smart servos must be your first choice.
These servos are perfect for serious IMAC competition aircraft as well as giant scale aircraft, or anywhere where you require one of the best servos on the market.
Programmable Features:
• ID change
• Reverse
• Neutral adjust
• Travel adjust
• Stretcher
• Dumping
• Deadband
• Boost
• Alarm level
• Alarm delay
• Angle (120°/180°)
• Slow start on/off
• Stop mode (free-hold)
Specs:
Input Voltage: 4.5~8.5V
Torque: 23kg@4.8V, 29.6kg@6.6V, 36.5kg@7.4V
Speed: 0.20sec@4.8V, 0.16sec@6.6V, 0.13sec@7.4V (sec/60°)
MPU: 32Bit
Control Frequency: 1kHz XBus, 333Hz PWM
Gears: Metal
Bearing: Dual ballbearing
Case: Glass filled nylon with metal heatsink
Dimensions: 35 x 21 x 40.5mm
Weight: 72g
Lead Length: 300mm
Included:
JR NX8921 Servo
Servo accessory pack
Notes:
* Do not use this servo with any other voltages other than those specified.
** If used on a large control surface - typically aileron, rudder, elevator or flaps on an airplane, digital servos may move slightly around center while on the ground. This is an expected phenomenon, and will not occur in the air.
-
Servo Torque(kg)(min. 0.01kg) 36.50
-
Servo Speed (Sec/60deg) 0.13
-
Servo A(mm) 46.00
-
Servo B(mm) 40.00
-
Servo C(mm) 40.00
-
Servo D(mm) 21.00
-
Servo E(mm) 56.00
-
Servo F(mm) 27.00