Jumper T12 Transmitter w/JP4IN1 Multi Protocol Transmitter Module (Mode 2)

The Jumper T12 Multi-Protocol Transmitter is very versatile and comes with JumperTX firmware (based on the OpenTX Project). There is a JR style module bay in the back that comes with the extremely versatile Jumper JP4-in-1 module that allows communication with a wide range of protocols such as Walkera DEVO, Spektrum DSM2/DSMX, Flysky, Esky, Frsky, WLtoys, Hubsan, Hisky, Futaba SFHSS Assan etc.

This release of transmitter now supports TBS crossfire and in CRSF mode with LUA script support and more importantly without any hardware modifications. It also comes with the smooth V2 gimbals from the T8SG V2 to provide excellent control. The 1.7inch 128x64 LCD screen allows easy viewing for setting up your models. There are four 3-position switches, two 2-position switches and two dials for all your devices. The transmitter can use up to 12 channels depending on the receiver type.

The JP4IN1 module integrates the CC2500, NRF24L01, A7105 and CYRF6936 RF chips into one PCB. The JP4IN1 is an OpenTX original accessory which can do serial digital signal communication with the Frsky series radios. Recognizing PPM signal from radio output, then converted to the corresponding radio protocol to achieve control of the fixed wing and drone aircraft.

For supported protocols: www.jumper.xyz/t12

The Jumper T12 Radio Transmitter is easy to use and the module bay allows for lots of different protocols to be utilized.

Features:
• JumperTX (open source Firmware set based on the OpenTX Project)
• JR/FrSKY compatible module bay on the rear side
• USB online firmware upgrade
• Ultra-low power consumption, longer battery life
• Up to 16 channel output
• Open Source Firmware, all channels are fully programmable
• Multilingual menu
• Vibration reminder function
• Support telemetry (depending on the receiver)
• Crossfire CSRF Compatible
• LUA Script support

Radio Specs:
Radio MCU: STM32F205VET6 (512kb)
Size: 158x150x58mm
Weight: 342g (without battery)
Working voltage: DC5-DC9V (factory with 4 x AA battery box, 2s Lipo recommended, batteries not included)
Firmware: JumperTX (an open source Firmware set based on the OpenTX Project)
Channels: up to 16 channel output
Display: 1.7-inch LCD display, 128x64 resolution
Gimbal Type: Potentiometer
Upgrade method: USB online upgrade
Simulator mode: 3.5mm standard ppm output or USB HID
Voice support: Yes

JP4-in-1 Specifications:
Working voltage: 6-9V
Working current: <=100mA
Operating frequency: 2.4GHz ISM band
RF power: +22DBM
Main control chip: STM32F103CBT6 (128K ROM, 20K RAM)
Module bay compatibility: FRSky, JR and other 
Dimensions: 64x49x33mm (without antenna)
Net Weight: 42g (including antenna)
Software Compatibility: Suitable for radios using OpenTX or er9x/ersky9x
Firmware updatable: Yes, via USB

Includes:
Radio Transmitter with module
Neck Strap
USB Cable
Instructions

Requires:
4 x “AA” Batteries or 2S Lipo