External status LED module, suits Arducopter 2.5~2.6.
• APM status Display
• 2 independent red/blue LED's
• Directly plugs into APM A6~A7 port
Length of Leads: 250mm
*Note: This is not an original Arduino brand product.
Very small module.
You can connect this to the A6 and A7 of your APM 2.x and will provide you a very bright led indicators.
If you are running Arducopter 3.1.5 or before, you have to activate the led output in mission planner. On 3.2.x or later its's already activated by default.Very bright leds and easy to install on APM. I only wish it had some kind of case to mount it in or shipped with some clear heat shrink to help protect it from moistureJust pluged into my APM 2.6 with no problem. A6 and A7 pins but had to change the LED_MODE parameter to 3 using mission Planner. It works like a charm! Very useful.Ordered this for mt HKPilot Mega and works like a charm! 2 Leds (Blue and Red) for Arm and GPS indication. Chip board is well made and has 2 holes for mounting. The 3 wired servo connector connects to A6 for GPS Lock indication (Blue) and the single connector connects to A7 for Arm/DisArm indication. Once plugged in, they flash similar to the small LEDS on the board but now externally and pretty bright even being powered by from the FC! Wires connect directly. In case anyone is wondering, yes the red wire in the 3 wire connector needs to be plugged into the FC, This powers the LED board (shown by a tiny blue LED indicating power in). The Main Blue/Red LEDS will start flasing once connected! Recommended for a small and great add on to the Pilot Mega board!plug n play apm analog output 4 and 6. mimmics the red a blue APM board led's for armed and GPS lock. Put a KK piezo buzzer on channel 5 for audible alerts