Matek RGB 8 LED WS2812B w/ MCU Dual Modes
A great LED strip for multirotors for night flying or other applications. Seven Colors that can flash or stay constant.
• Dual modes: MCU control & Cleanflight control
• MCU mode, 7 colors (White, Green, Red, Blue, Yellow, Cyan, Magenta)
• Four LED states (Constant light, Slow flash, Fast flash, Violent flash)
CF mode: supports CC3D, Naze32, SPRacingF3, etc. with CleanFlight firmware
Working voltage range: 4.5~5.2V DC
Power of MCU mode (5V IN): White: 1.8W /0.36A
Mounting: 30mm, Dia. 2.6mm
I just installed two of these on my quad. You read that correctly, two! The strip does not have a DOUT port, but after some searching i found out that if you use the bottom right leg of the rightmost led (orientation with connectors up) you can get the DOUT from there. Not five stars for quality because i feel this should this a design ommission. Love the brightness and the clever spacing of the leds though, makes mounting easy!I am using this with betaflight, works fine. This is not my video, but it did help me make it work with the flight controller. https://www.youtube.com/watch?v=9IZKeWsM8_sreally nice strip. easy to configure and the dual mode is just perfect. You can switch from the programmable version from cleanflight to the MCU mode for steady or flashing conditions in 2 seconds!!!
jjp download now [1.48Mb] Datenblatt download now [347.03Kb] Setup for Flight Controller download now [329.13Kb] Setup for Flight Controller download now [329.13Kb] Setup for Flight Controller download now [329.13Kb]