Introducing the all new Quanum Q-2D brushless camera gimbal, which is designed for use with the GoPro Hero 3 on 350 size quadcopters such as the Quanum Nova, QR X350 PRO and DJI Phantom.
When it comes to a great aerial video platform a few things are key; design, size, weight and performance. The Q-2D is a design that has been optimized from the start for proper integration, saving on size and weight and the pre-tuned controller performs just as you would expect from Quanum.
The Q-2D is one of the smallest and lightest brushless gimbals on the market. At just 84mm tall, it can clear most multi-rotor landing skids and only weighs 120g, perfect for 350 sized quad copters. Both pitch and roll can be adjusted on the fly from an R/C channel and has a huge operating voltage range of up to 28 volts.
The Q-2D is pre-tuned from the factory, requiring no setup, simply bolt on to the bottom of the Quanum Nova, QR X350 PRO or DJI Phantom, install your GoPro Hero 3 camera and you're ready to shoot professional stabilized aerial video!
• Lightweight yet duable aluminum construction
• Compact size
• Adaptable to most 350 quadcopters (direct fit for Nova, QR X350 PRO and DJI Phantom)
• Pitch and roll inputs
• Support for the GoPro Hero 3 video aux output
• Huge input voltage support (7.4~28V)
• Power supply voltage reverse connection protection and voltage compensation
• Motor drive side short circuit protection
• Initial pitch angle
• Sensitivity parameters adjustment
Operating voltage: 7.4V~28V DC (recommended 12V, 3S lipo battery)
Work current: 200mA~500mA
Working environment temperature: -15~65C
Sensors: Three MEMS gyroscope rotor and rotor MEMS accelerometer
Maximum angular rate: 2000 deg/SEC
Maximum acceleration: 16g
Control frequency: 1000Hz
Motor drive frequency: 32kHZ (noiseless smooth drive)
Accuracy: 0.1 deg
Control Range: - 45~45 (Roll), - 135~90 (Pitch)
Applicable filming equipment: GoPro Hero 3 or iLook
Mounting: Upper plate adapter holes centerline 30~40mm hole to hole
1 x Quanum Q-2D Brushless Gimbal
2 x Servo leads for pitch and roll control
1 x Balance accessory for use with heavier cameras (not required for use with GoPro Hero 3)
1 x Power adapter to mini JST
*Note: User manual available for download located under the "Files" tab below.
Good so far recommended. Works as described, will buy again.Good so far recommended. Works as described, will buy again.Good so far recommended. Works as described, will buy again.Good so far recommended. Works as described, will buy again.Haven’t used yet but will update whenNext video made this glimbal.
https://www.youtube.com/watch?v=XATGo4TMGjQNext video made with glimbal.
https://www.youtube.com/watch?v=XATGo4TMGjQMy Turnigy 2K Cam (SJ4000plus) is a bit heavy for that gimbal so i removed the battery and now it works much better.All I have is problems with this Gimbal when I am flying with it it keeps on tilting to one side and I am using a GoPro 3 I have taken the weight off it doesn't make a differencenice and light. made very well and is nice and smooth. put the turnigy action cam into the holder with the screw from below cant wait to get my quad ordered this after my nova and got this way ahead of the quad probably customs. it'll get here