Input Voltage : 7.4V~11.1V (2~3S Li-po)
Kv : 1450rpm/V Â} within 10%
Max. efficiency current : 15~25A
Current capacity : 35A/30s
Dimensions : 35mm X 36mm / 1.38in X 1.41in
Shaft diameter : 4mm / 0.16in
Weight : 106g / 3.74oz
Number of poles/magnets : 14
Recommended model weight : 1000~1900g / 35~67oz
Power equivalent : .25 to .30 IC glow engine
Suggested propeller: 9x6
Max Currents (A)
Length B (mm):
Can Length D(mm)
Unit Weight (g):
Total Length E(mm)
Installation in SkyWalker.
3S LiPo, 9x6 APC prop.
Great price for a motor with accessory pack.
Did not use the accessory pack though.
Pulled shaft out and reversed.
Running prop-adapter directly on shaft.
Will also use the 9.5x5 folder on this.
Numbers to follow.ESTE MOTOR TIRA COMO UN COHETE , ESTAS SON MIS MEDICIONES.
HELICES 9*6 - BATERIAS TURNIGY 2200 mAh. 3S 25C - PICO DE WATIOS 467 W - CONSUMO 44A. LO TENGO MONTADO EN UN BLIZZARD DE MPX Y VA DE LUJOI have this motor installed in my Multiplex Gemini. The recomended 9x6 prop is to much for this motor. I'm using the apc style 8x6, flightmax 2200mah 3s1p. My hobbyking wattmeter indicates about 58 amps and over 600 watts at full throttle. Vertical performance is insane. I hand launch this plane from my left hand, throttle up with my mouth at wich time this monster rips from my fingers and I control the climbout I would not keep at full throttle for more then 10-15 seconds. I have six flights on this motor, average eight minutes flight time. Will report back after 30. Have my doubts about it lifespan with the 8x6.This motor is a beast. I run it way past specs with a 3s battery, 60 amps ESC, and 9x6 prop on a T28 which draws 52 amps right at 600 watts. I, also run it on a 4s battery but haven't taken a reading as I don't want to get near the prop. On 3s it's very fast on 4s it's insane. Very short bursts only. I notice this motor isnt't even rated for a 4s battery.. Who would of thought!Yo compr ya 2 motores, y funcionan muy bien. COn el primero me estrell de frente, el motor se aboll, pero no ha dejado de funcionar, a pesar incluso de que se pelaron los cables por el choque, solo los volv a cubrir con cinta, y sigue funcionando correctamente.
Muy buen motor !! Very well motor, it works fine !!great motor. I have 6 of these now and love them.. I have 3 of them in eflight mini sticks. mine and my sons has turnigy 60amp plush esc,tgs 8x7e prop, I use 2 turnigy 1450mah 2s 30c batteries in parallel for 2900mah 2s and turnigy 2100mah 35c 3s. my freinds (I take care of) has thunderbird 54 esc, tgs 8x7e prop, 2 turnigy 1800mah 30c 2s in parallel. one 2 meter glider converted to electric (no slopes here) with a turnigy 40amp plush esc. tgs 8x7e prop, 2 turnigy 1800mah 30c 2s in parallel. and a ninja glider with a turnity 40amp esc, apc 8x7e prop, 2s 3600mah. and one spare that has not been used yet. on 2s they pull 30-32amps, and on 3s they pull almost 50amps. you can only run at full throttle on 3s for short amounts of time but at full throttle it gose to fast for plane in level flight and will go straight up as far as you want, so no problems. 2 have well over 100 flights on 2s. 2 have close 100 flights, with one of them getting some flights on 3s. last one only has a few flights.Using this motor on a Parkzone T28 with an aluminum motor mount.
50 amp ESC
APC 9x6e Prop
Turnigy 2200 30C lipo
With 2 ounces added weight in the back by the rudder servo.
48 amps 530 watts peak.
The plane just goes straight up forever.
Hello, I just measured the resistance of this motor
The resistance of 3 windings is 82, 60 and 77 mohm.
73 mohm is average.I bought 2 Motors,one ist good, one runns very loud with vibration!Este motor para mi blizzard de mpx va sobrado de potencia y ademas le rebajamos alguno gramos de peso , con una helice 9*6 va como un tiro y no hace falta poner lastre en el velero . Aconsejable 100