Turnigy 2615 EDF Outrunner 3000kv for 55/64mm

• Overall
• Quality
• Value

Certified Buyer Rated

Feb 27, 2014

A bit dissapointed with this motors now. They used to have 0,2mm stator plates, but now they have 0,35mm... probably a cheaper stator. The results is lower efficiency for the motor.

They do include 2 shafts, one with a 2,3mm (micrometer=2,27) tip and one extra 3mm (2,97 with micrometer)

• Overall
• Quality
• Value

Certified Buyer Rated

Jun 19, 2011

This motor will power my new Babycat (Flycat) model with Tgs 4.75x4.75 prop, 25A ESC and 2S 1800mAh lipo cells.



In that configuration motor draws around 17A and produces 125W. More than enough power for small Babycat (800mm wingspan). With Tgs 5x5 prop you get 19A or 150W...



Motor is well made and came with 3mm shaft. Included are also another 3mm shaft and 2,3mm!



Only cons that I found is that there is no e-ring on the shaft. Most outrunners have e-ring or collar with grub screw, which fixes the rotor.

• Overall
• Quality
• Value

Customer Rated

Jun 05, 2011

I'm using this motor in the Phase-3 Fantom/Phase-3 F-16 55mm three-blade fan unit on 4-cell 1750-2200 lipo, draws about 35 amps at full throttle and nice power upgrade for the original KMS 20mm inrunner motor. Also using on GWS F-15 on 4-cell 1750 and it works quite well. Will fly Phase 3 EDF Fantom on 3-cells as well, but performance is less.



Tried the 2810 motor first on the Fantom, but it burnt the windings on a 4-cell flight.



Great replacement for the orginal KMS 5100 KV inrunner motor if you want to fly on 4-cells instead of 3. One third the cost of the original motor.

• Overall
• Quality
• Value

Customer Rated

Aug 24, 2010

In Hawk 64mm Impeller mit 4S LIPO: 40'000 rpm, 600g Schub. Sehr gut!

• Overall
• Quality
• Value

Certified Buyer Rated

May 15, 2010

put this on a 7 blade 64mm fan only made 270 grams of thrust on 11 volt lipo maybe it will do better on a 68mm fan because 270 grams isnt going to hardly move a 64mm jet

• Overall
• Quality
• Value

Customer Rated

Apr 23, 2010

Tested with the blue EDF64mm also sold here:



Thrust(g) Amps Battery

200 5.1 800 3s20c

270 8.5 800 3s20c

330 10.0 1800 15c

370 12.3 1800 15c

440 15.0 2200 20c



My set resonates somewhere between 200-270g of thrust where light rubbing of the fan and case occurs. With that said the motor is smooth and remarkably quiet. This is quite a low current setup probably more suited for lighter 300g-400g AUW planes.