The Turnigy AE series are based on new powerful microprocessor.
The new CPU means ultra fast sync timing, crisper throttle response, less battery load and reduced FET heat buildup. Also there is a separate voltage regulator IC for microprocessor providing good anti-jamming capability.
Output: Continuous 30A, burst 35A up to 10 seconds.
Input Voltage: 2-4 cells lithium battery or 5-12 cells NIMH battery.
BEC: Linear 2A @ 5V
Control Signal Transmission: Optically coupled system.
2 Pole: 210,000rpm
6 Pole: 70,000rpm
12 Pole: 35,000rpm
Size: 50mm (L) * 26mm (W) * 12mm (H).
High performance microprocessor brings out the best compatibility with all kinds of motors and the highest driving efficiency.
Wide-open heatsink design to get the best heat dissipation effect.
Improved Normal, Soft, Very-Soft start modes, compatible with aircraft and helicopter.
Smooth, linear, quick and precise throttle response.
Multiple protection features: Low-voltage cut-off protection / Over-heat protection / Throttle signal loss protection
Programable via transmitter
Brake setting (we recommend using brake for only folding props applications)
Battery type(Li-xx or Ni-xx)
Low voltage cutoff setting
Factory default setup restore
Timing settings (to enhance ESC efficiency and smoothness)
Soft acceleration start ups (for delicate gearbox applications)
Low voltage cutoff type (power reduction orirnmediate shutdown)
Factory default settings:
Battery type: Li-xx (Li-ion or Li-Po)
Low voltage cutoff threshold: Soft cut-off (2.6V)
Timing setup: Low
Soft Acceleration Start Up: Normal
Low voltage cutoff type: Medium
*Please see "Files" tab for ESC manual w/programming instructions
Good quality Esc, powerfull and small.
Dosen't necesary needs to strip away the transparent cover for extra cooling.
Just make sure not a drop of water touches this while is pluged on the battery, it will burn instantly.fantastic ?? trunigy for ever.... tank you.Occasionally acts a bit strange initializing - restarts several times on battery connect, but so far has not let me down in the air.Dont use it for copters (Quadro) "Battery Protection Voltage Threshold-Function" stop Motor in the air and copter crashes!! but it's a very good ESCBEC does not work on 4s (servos stutter)
Motor does not spin, stutters. Tried all timing settings.
Don't waste your time on this product.Schrott, BEC funktioniert nur bis 3 Zellen, bei mehr Zittern die Servos.
Nach 3 Flgen stotterte der Motor nur noch, alle Settings und andere Motoren/ESCs probiert, liegt definitiv am AE30A. Ein Produkt das keiner braucht.Not usable at 4S, servos starts to jitter, motor starts to run (even if you connect just 1 servo).
3S ok, but tested only up to 12 Ampere
was looking for a esc for my new phoenix as I upgraded the motor and this did the trick and came very fastI use this esc in my Hobbyking 250GT heli & find it to be a very high quality reliable esc.This is goog ESC. I have good experience with it, therefore I recommend this product.
No File Name download now [211kb] User Manual download now [211kb] HK manual TAE ESC download now [109kb] No File Name download now [109kb] No File Name download now [211kb] No File Name download now [4kb] No File Name download now [109kb] Theunsie s setup manual better explaine download now [4kb] Theunsie s setup manual better explaine download now [4kb] Theunsie manual corrected download now [4kb] Manual Speed Turnigy em portugues download now [3kb] Programmation SÃ©rie AE en FranÃ§ais download now [216kb] Programmation SÃ©rie AE en FranÃ§ais download now [2kb] Turnigy AE-30A proper setting download now [2kb] No File Name download now [109kb] Build 450 with this component download now [602kb]