Turnigy Aerodrive SK3 2822-1275 Brushless Outrunner with Short Shaft

• Overall
• Quality
• Value

Bien !

Jan 30, 2020

Good power for this cheap and light motor : I love it !

• Overall
• Quality
• Value

Very good value item.

Apr 29, 2019

Fast delivery, item as described. All round good value.

• Overall
• Quality
• Value

Certified Buyer Rated

Aug 21, 2016

Nice engine, my standard engine for light twin ESA/EPA planes. I use two one with a 7x5APC and a 3S 2200mAh Zippy compact for 7 minutes at full throttle

• Overall
• Quality
• Value

Certified Buyer Rated

Mar 17, 2016

i use it with 8045 props and works very well, quite and powerfull

• Overall
• Quality
• Value

Certified Buyer Rated

Jul 26, 2014

super powerful on the scorpion Y6 frame, even using the flimsy glow in the dark props

• Overall
• Quality
• Value

Certified Buyer Rated

Jan 07, 2014

These are very good motors. They run smooth and efficient with 8045 SF props on my SK450 quadcopter. I like how 3mm bullet plugs come pre-soldered! The best thing about these motors is that they only draw a max of 8 Amps! You only need 10A ESCs, but I use 15A multistar ESCs for extra safety (and they come with 3mm bullets). All in all a very good motor!

• Overall
• Quality
• Value

Customer Rated

Dec 09, 2013

Beginners mistake. Ran these with a 30A turnigy plush speed controller, so they got mighty hot. Will order some 10A which look more suitable according to pls comments. Using a kk2.0 board, which needed firmware upgrade before the motors ran in all at once. Smooth motor. Good power on my dead cat - although not sure how it will run with 10A speed controllers. One downside, the 3 small screws (M1.5 hex)!for the prop mount are weak. Snapped some from over tightening, then I learnt my lesson, but the some snapped after one crash, and another whilst in flight. Recommend you replace these with strong bolts. Bullet connectors are 3.5mm, but I had to first give them a squeeze with needle tip pliers to get them to fit the gold connectors I purchased.

• Overall
• Quality
• Value

Certified Buyer Rated

Oct 10, 2013

My favourite motors for F330 frames. Real smooth and with 3S 25Cplus LiPOs they have nice punch with 8045 props.

• Overall
• Quality
• Value

Certified Buyer Rated

Sep 05, 2013

Good motor. I bough 5 for a quad, one is kind stuck, so I left it for a later replace if needed. It has good performance with 8x4.5 and I got over 12 mins flight with a 800g quad (33cm frame). Although all the motors seems slightly 'lose' on the bearings since I can move it side ways.

• Overall
• Quality
• Value

Customer Rated

Aug 23, 2013

Using these with the hobbyking blue 12a esc, f330 frame and kk2 with a 3s lipo. Nothing to complain about. Bought 5, one as a spare, had a few good crashes and these are still going like new. Only negative is these should come with lock nuts as I had a prop fly off, lucky it hadn't lifted of the ground yet.