Turnigy Aerodrive SK3 - 6374-192KV Brushless Outrunner Motor
Turnigy Aerodrive SK3 - 6374-192KV Brushless Outrunner Motor
Copy and Share the Below URL
Turnigy SK3 Motors are the next leap forward in motor quality and design. We instructed the engineers to source the best quality magnets, bearings and materials available to them and develop a motor that would not only rival but surpasses the quality of many leading motor manufacturers on the market today.
The result is an efficient, high-caliber motor using quality double shielded bearings, sintered Neodymium magnets and a string wound stator ensuring an accurate and consistent winding each and every time.
The Turnigy SK3 motors are suited to modelers who are seeking a quality brushless motor without compromise.
Specs:
Turns: 14T
Voltage: 10~12S Lipoly
RPM/V: 192KV
Internal resistance: 0.016 Ohm
Max Loading: 80A
Max Power: 4032W
Shaft Dia: 8.0mm
Bolt holes: 32mm
Bolt thread: M4
Weight: 858g
Motor Plug: 4.0mm Bullet Connector
-
SKU SK3-6374-192
-
Brand SK3
-
Shipping Weight 1288.0000
-
Packaging Length 175.00
-
Packaging Width 70.00
-
Packaging Height 135.00
-
Kv(rpm/v) 192.00
-
Max Current (A) 80.00
-
Resistance (mh) 16.00
-
Max Voltage(V) 44.00
-
Power (W) 2750.00
-
Shaft A(mm) 8.00
-
Length B (mm) 86.00
-
Diameter C(mm) 59.00
-
Can Length D(mm) 61.00
-
Total Length E(mm) 113.00
-
SK 3 6374 168kv Brushless Motor
35 pound tigercat conversion to electric, same power as g45s, 4 minute flight on 5000 ma, same props, pleanty of power.
35 pound tigercat conversion to electric, same power as g45s, 4 minute flight on 5000 ma, same props, pleanty of power.
Mejlik 18/10 3 blade 12 cell was over 80 amps, went with 11 cell, 3200 watts 75 amps on fully charged 5+6 cell series 5000 ma. Hoping for good reliability under the 80 amp motor specs.
Mejlik 18/10 3 blade 12 cell was over 80 amps, went with 11 cell, 3200 watts 75 amps on fully charged 5+6 cell series 5000 ma. Hoping for good reliability under the 80 amp motor specs.
Has anyone measured the thrust with 18", 20", or 22" props?
Has anyone measured the thrust with 18", 20", or 22" props?
Guys can i use 6s battery?
Guys can i use 6s battery?
I installed this motor in the new 30% RV-4 from Hangar 9. Used AeroStar Advance 150A HV (6~12S) Brushless ESC (Opto) and YEP 20A HV (2~12S) SBEC. Turnigy 19x10 cherry wood prop. Battery power is two Heavy Duty 6S 5000mah 60C Lipos in series.
Flight times with throttle management of 9 to 10 minutes. Motor handles all that I can throw at it and never gets hot.
I installed this motor in the new 30% RV-4 from Hangar 9. Used AeroStar Advance 150A HV (6~12S) Brushless ESC (Opto) and YEP 20A HV (2~12S) SBEC. Turnigy 19x10 cherry wood prop. Battery power is two Heavy Duty 6S 5000mah 60C Lipos in series.
Flight times with throttle management of 9 to 10 minutes. Motor handles all that I can throw at it and never gets hot.
I am using this motor in a 1/3 scale Balsa USA low wing Fly Baby. I have not done any tests yet but have a few flights on it so far. 12s 5000mAh on 20x10 prop has plenty of power. Going to get two more for a Ziroli Beech D18 if it holds up well after I get many more flights logged in with it.
https://youtu.be/7EygKIy2pcc
I am using this motor in a 1/3 scale Balsa USA low wing Fly Baby. I have not done any tests yet but have a few flights on it so far. 12s 5000mAh on 20x10 prop has plenty of power. Going to get two more for a Ziroli Beech D18 if it holds up well after I get many more flights logged in with it.
https://youtu.be/7EygKIy2pcc
perfect for electric skateboards, good torque and very sturdy. over 300km of riding now and the motor is holding up fine.
perfect for electric skateboards, good torque and very sturdy. over 300km of riding now and the motor is holding up fine.
https://youtu.be/u_OtD5EA01Q
https://youtu.be/5abhU6CMW2g
I have 3 of these. My buddy also uses the same. Over 1k flights so far and rock solid. We use it at 4000watts on a daily basis. I have pushed to 4500watts with a 22X10 as well and also was OK.
https://youtu.be/u_OtD5EA01Q
https://youtu.be/5abhU6CMW2g
I have 3 of these. My buddy also uses the same. Over 1k flights so far and rock solid. We use it at 4000watts on a daily basis. I have pushed to 4500watts with a 22X10 as well and also was OK.
Good motor.
I used two of them on an electric mountainboard for a year now. Together with the X-Car Beast 150A ESC.
On 5S I only use like 1500W of the power it can give. Still gives me 3KW power in total which is plenty.
Modified with hall sensors for smoother acceleration and braking, works like a charm.
There are three screws on the side, one of my motors came with a fourth screw. Inside the motor attracted by the magnets near the windings. Must have fallen in there during manufacturing.
Good motor.
I used two of them on an electric mountainboard for a year now. Together with the X-Car Beast 150A ESC.
On 5S I only use like 1500W of the power it can give. Still gives me 3KW power in total which is plenty.
Modified with hall sensors for smoother acceleration and braking, works like a charm.
There are three screws on the side, one of my motors came with a fourth screw. Inside the motor attracted by the magnets near the windings. Must have fallen in there during manufacturing.
High quality motor! the package was destroyed but luckily the motor didnt break.
High quality motor! the package was destroyed but luckily the motor didnt break.
| No File Name | Download [1811] |
| 6374-192KV | Download [2098] |
| 6374-192KV | Download [2098] |
| 6374-192kv for pilatus porter pc bird | Download [1036] |
| 6374-192kv ebike | Download [96] |
| ebike 192kv 6374 | Download [99] |
| SK3-6374(DT5045-14P) MOTOR (edited).pdf | Download [119] |
Only registered users can upload files.
Please log in or register to start helping your fellow hobbyists today!
Related Tags
Combine Essential Items and Save
Others Also Bought
-
Turnigy Skateboard Conversion Kit Spare Pa...SKU: 9192000363-0
$9.13 -
XT90-S Anti-Spark Connector (2pairs/bag)SKU: 015000177-0
$6.01 -
Turnigy High Quality 10AWG Silicone Wire 1...SKU: 171000713-0
Special Price $2.36
You save $1.20
Was $3.56
-
Turnigy Skateboard Conversion Kit Spare Pa...SKU: 9192000361-0
$24.48 -
Turnigy High Quality 10AWG Silicone Wire 1...SKU: 171000712-0
$3.56
Related Products
-
Turnigy Aerodrive SK3 - 63-XX Spare Access...SKU: 192000006
$7.50 -
Turnigy Aerodrive SK3 6364/6374 Series Rep...SKU: 192000085
$19.30 -
Turnigy Aerodrive SK3 6374 Series Replacem...SKU: 192000025
$5.19