The Turnigy AquaStar Sensorless Brushless Motors offer outstanding performance for your boat at an incredible price!
Featuring a quality CNC machined billet T6 aluminum motor can, hand-wound high purity copper windings and powerful sintered neodymium magnet, you will not find a better priced motor of this caliber anywhere else! It even features a billet aluminum water cooling jacket pre-installed.
The AquaStar brushless motors are a great choice for your deep-V, hydro or catamaran race boat and will be sure to leave the competition in your wake!
• CNC machined billet T6 aluminum motor can
• High purity copper windings
• 4mm bullet connectors pre-installed
• Powerful sintered neodymium magnet
• Precision engineered for maximum energy conversion
• Water cooling jacket pre-installed
Max voltage: 25.9v (7S)
Max Current: 72A
Max Watts: 1800w
No Load Current: 2.9A
Can Diameter: 36mm (actual motor diameter)
Can Diameter inc. Water Jacket: 44mm
Can Length: 60mm
Shaft Size: 5mm
Max Currents (A)
Length B (mm):
Can Length D(mm)
Unit Weight (g):
Total Length E(mm)
abolutely wrong specs. As other customers refer, this motor can't run with 6S LiPo cell, it burns after few seconds, magnet cracked and smoke everywere.
If you want to run it with 3 or 4 S it's ok. Poor internal mechanical design.I forgot one piece of important information . I am running 2) X445 props surface piercing cupped and balanced . Again A on the motors and speed controls.I am running two of these bolted to 2) Graupner 800 gtx gear driven outboards on a 40 inch Dumas hull that weigh's total 12 1/2 lbs. Prop shafts are even with the bottom of the boat. Not the bottom of the V. So if your looking from the back of the boat, The center of the propshaft is even with the hull directly in front of it. This height eliminates load on speed controls.I am running 2) 120 Amp Aquastar ESC"s and 2) 4S batterys. The boat does 38 MPH for 20 min no heat problem , Boat has built in water pick ups on bottom of hull. I give these motors a A rating ,Powerful!