The Turnigy Marine waterproof speed controllers are packed with the latest technology and are up there amongst some of the best on the market today. These speed controllers have reached the ultimate IP67 level of protection (Ingress Protection), this is the standard that electronic devices are tested to. The 6 on the IP rating means it is "Totally protected against dust", the 7 on the IP rating means it is "Protected against immersion between 15cm and 1m.
The Turnigy Marine speed controllers are supplied with a "Copper Bar Heat Technology" water cooling system (exclusively patented) and extremely low internal resistance MOSFET's. Each one has specially designed software which features excellent start-up and acceleration performance, they have an outstanding amount of "punch" when coming out of turns when used in high speed boats. A waterproof on/off switch is fitted so that you can connect the battery then seal the hatch, the radio can then be switched on when you are ready to go.
2 running modes can be selected, either forwards only or forwards and reverse. The speed controllers also have multiple protections as shown in the features list below. Programming of the many features of the speed controller is easily done using your transmitter.
• Patented water cooling system
• Excellent start-up and acceleration performance
• Bags of "punch" when accelerating out of turns
• Fitted with waterproof on/off switch
• 2 running modes can be selected (forwards only or forwards
• Programmable via the transmitter
• Program modes: running mode, LiPoly cell count, low
voltage cut-off, timing
• Overheating protection
• Low voltage cut-off protection
• Signal loss protection
Voltage Input: 2~3 LiPoly cells (4~9 NiMh)
Continuous Current: 30A
Burst Current: 180A
BEC Type: Linear with on/off switch
BEC Output: 6V@1A
Motor Connectors: 3.5mm
Servo lead: JR style
Servo Lead length: 150mm
Water Cooling Pipe: 2mm I/D~4mm O/D
Please note: This speed controller is not supplied with a battery connector.
what esc programm i have to use .the reverse is 60% of power i would like 100% reverse power.
ok found the sollution to connect 2 esc's on 1 transmitter.connect the 2 esc's and switche the 2 switches on ;leave the red lead in the connectors and it works like it should be working .try to put 2 esc on one reciever and it wont work .disconnect the red lead off one of them and beep beep beep wont work.put a bec on the reciever and disconnect the 2 red leads .wont work .some one a sollution .its two turnigy marine 30 amp
Super petit variateur (car il est vraiment petit) idéal dans les micro coques !!
Fonctionne très bien en 2s 2200mahGood speed controller had a bit of trouble to set up would make it easier if all cables where colour codedKompakter Regler mit 39gr. 2,6 gr. wiegen alleine die etwas zu gross geratenen Kuehlanschluesse. Laesst sich prima mit der Tyrnigy Marine Progcard einstellen. Sehr feines Regelverhalten.