MultiStar ESCs are a quality speed controller at a fantastic price! Designed for simple installation and easy setup these ESCs have proven to offer excellent performance when used in Multi-rotor applications. If your starting out in Multi-rotors and need an easy to install solution that is tested and proven to work with Multi-rotor craft then these speed controllers have you covered.
These ESC's features a very smooth yet linear throttle response, without sacrificing a rapid, crisp, response to any throttle input. Safety is not forgotten with all Multistar Esc's featuring adjustable battery LVC (set battery type to LiXX to disable LVC), stalled motor (overload) protection, signal loss shut-down and safe arming.
All Multistar series ESC's come with bullet connectors installed that are suited to the ESC's rated power handling. This allows for plug and play convenience by simply adding the appropriate battery supply splitter (3,4 or 6 ESC) and motor lead extensions from the Multistar modular accessory line. What could be simpler?
All Multistar ESC's feature an ATmega MCU that opens the door to customizable firmware - for those so inclined! or alternatively a programming card can be used with the installed software for quick and easy setup with the pre-flashed software.
Please refer to the related items below for a solder free multi-rotor power solution to suit your next multi-rotor project.
• Smooth and linear throttle control
• Fast response to throttle input
• Atmel MCU
• Stalled motor protection
• Throttle signal lose protection
• Safe power-on (throttle lockout)
• Support 480Hz+ high refresh rates (up to 499hz)
• Compatible with programming card
Constant Current: 30A
Input Voltage: 2-6 cells Lipoly
BEC: Yes (Switching) [Remove middle wire to disable]
BEC Output: 5V/4APWM: 8 KHz
Max RPM: 240,000rpm for 2 Poles Brushless Motor
PCB Size: 41mm x 24mm
Discharge Plugs: Male 3.5mm Bullet Connector
Motor Plugs: Female 3.5mm Bullet Connector
User manual now available for download under "Files" tab.
I bought 4 of this ESC´s and I am quite impress. One wasn´t working, but after throttle range calibration it went fine.great ECS's. stay cool with my 690kv 22pole multistars.I bought 4 and found out one of the BEC circuits were bad, too much voltage, which fried my flight controller. Measure bec voltage before connecting to anything that requires 5volts. I put in an RMA and HobbyKing sent me replacements so I am happy about that. Also be sure to get the V2 programmer just to make sure they are set up the same.I didn't try to use this guy it because i dont have this kind of connector here. But seens a nice ESC.
FYI, i will use to a quadcopter with NTM motors 200w each.I wired an XT-60 power connector on backwards like a retard while making my own Y splitter cable (even though I've soldered dozens of these connectors on before) and ran reversed power out to two of these ESCs. Normally that would be a death sentence, but they both survived and still work! That's the first time I've ever seen an ESC survive reversed polarity on power.
Now if we could just get HK to post a manual for these.perfecto y buena calidad decentes y buen precioI buy 6 of these ESCs 2 of them was Broken i ask Hobby King for a Resend and HobbyKing send without any Problems a new oneSensitive input
I have blown both by connecting and disconnecting.
Never happend by version 1 Multistar