MultiStar ESCs are are a quality speed controller at a fantastic price! Designed for simple installation and easy setup these ESCs have proven to offer excellent performance when used in Multi-rotor applications. If your starting out in Multi-rotors and need an easy to install solution that is tested and proven to work with Multi-rotor craft then these speed controllers have you covered.
These ESC's features a very smooth yet linear throttle response, without sacrificing a rapid, crisp, response to any throttle input. Safety is not forgotten with all Multistar Esc's featuring adjustable battery LVC (set battery type to LiXX to disable LVC), stalled motor (overload) protection, signal loss shut-down and safe arming.
All Multistar series ESC's come with bullet connectors installed that are suited to the ESC's rated power handling. This allows for plug and play convenience by simply adding the appropriate battery supply splitter (3,4 or 6 ESC) and motor lead extensions from the Multistar modular accessory line. What could be simpler?
All Multistar ESC's feature an ATmega MCU that opens the door to customizable firmware - for those so inclined! or alternatively a programming card can be used with the installed software for quick and easy setup with the pre-flashed software.
Please refer to the related items below for a solder free multi-rotor power solution to suit your next multi-rotor project.
• Smooth and linear throttle control
• Fast response to throttle input
• Atel MCU
• Stalled motor protection
• Throttle signal lose protection
• Safe power-on (throttle lockout)
• Support 480Hz+ high refresh rates (up to 499hz)
• Compatible with programming card
Constant Current: 45A
Input Voltage: 2-6 cells Lipoly
BEC: None (OPTO)
PWM: 8 KHz
Max RPM: 240,000rpm for 2 Poles Brushless Motor
PCB Size: 50mm x 30mm
Discharge Plugs: Male 4.0mm Bullet Connector
Motor Plugs: Female 4.0mm Bullet Connector
wish these came with 3.5mm bullets instead of the 4mm so they can match all the motors I use that need these to run 6s.i bought one it was bad had to jump threw hoops to get a replacement. when i got it, it was also bad. so i took store credit. i guess they dont test them before they are shipped. i went with the hobbyking 40amp instead and it works greatgot one it was bad. got a replacement it was bad also. i do not recomend this partIf you use a Naza or Wookong FC, and need a lot of lifting power....the 45A Multistar works very well....even with HK 490kv pancakes. Not sure why so many people give this product a bad rap, but I have to assume that everyone wants to be an "expert" and few really are (including myself). I have cycled these units in rapid acceleration bench tests (under load) with a 4S/5000mah battery...for extended periods, without a single failure (motor or esc). This is the perfect match for systems that need to replace DJI 30A OPTO's due to lower kv motor changes or higher lifting requirments. OPTO's are the answer, if your FC has power supplied by its own power unit, as all DJI products do.I'm running six of them at a Tarot T810 which is equipped with Turnigy Multistar 4822-490Kv 22Pole Multi-Rotor Outrunners. FC is DJI Wookong M. Performance of this huge Hexacopter is excellent, ESC/Motor Combo was a really great choice.Great speed controllers,I use them on my quad and they have seen there fair share of not so friendly landings.