Designed to provide reliable and clean power for 3D parkflyers. This brushless outrunner will provide more power and with its high efficiency, long run times.
A quality motor, built specifically for planes designed to fly with a 55 watts brushless outrunner.
Battery: 2 Cell /7.4V
Max current: 8A
No load current: 7.4V/0.20A
Internal resistance: 0.23 ohm
Weight: 16g (not including connectors)
Diameter of shaft: 2mm
7.4v - 7035 Prop - 5.5A - 255g Thrust
7.4v - 6030 Prop - 4.2A - 220g Thrust
Max Currents (A)
Length B (mm):
Can Length D(mm)
Unit Weight (g):
Total Length E(mm)
Bu motoru al?rken dikkat edin, saft geriye dogru uzanm?s, ileti ittirilmesi gerek. ?ok zor bir is ve genellikle saft k?r?l?yor.Nice motor with a lot of thrust. Great for foamies.Probably a great little motor but totally ruined by the fact that its almost impossible to reverse the shaft to use the collet.Sweet little thing. I have used it in my "One Sheet Glider"
I have had several "nose landings" but this motor is very rugged, still turns perfectly and with good thrust on 7035, 6030, and 5943 propellers.Guter Motor viel Power hinter dem kleinen, habe den hinaustehenden Schaft etwas gekrztReally versatile motor. I have a few of these and I'm satisfied with everyone of them. Ran to recommended specs they will last forever as long as you don't crash, break shaft etc. Don't place too much stress on the leads and avoid bending near the coils as this is their weak point. Can be pushed to 3S battery.Dieser Motor soll ein nachgebautes Graupner Topsy antreiben. Der Motor laeuft schoen rund und fuer seine Groesse recht kraftvoll. Keine Vibrationen feststellbar.This is a great Park Flyer Motor. I believed that this is a 9 Pole motor. You need this information to setup the RPM Sensors for the new telemetry systems now available. The mounting hole center's are 20.5mm for firewall mounting. One of the best in it's class for a Park Flyer 250 Motor.great little engine full of power, very surprised by it. if you want to invert the shaft, be aware that the 2 little black screw have been locked with a thread locker of some type and it's easy to ruin the inside of the screw.I am using this 2050kv park 250 in a scratch built super sportster, using a 6x4 prop. Flying weight is 8 oz. or 226 grams. Using a 460 nano-tech 2 cell and Hobby King 12 amp blue esc. Good motor and strong