This harness allows you to charge and balance 2 3S packs with a 6S port.
Compatible with our Accucel chargers and TURNIGY, Flightmax or Rhino batteries.
Uses JST-XH balance plugs and XT60 discharge plug.
Works good! However like some other users have noticed the soldering job can be better but not a big deal. Most people here know how to use soldering gun.Allows my 50W charger to charge 2x3S batteries at up to 2 amps. Works best with batteries of the same size & charge or balancing will take ages. I usually charge until one cell hits 4.2v, then top off each battery separately (especially if one has significantly less charge.)I'm charging 2x Turnigy 850MAH 3S lipos at once now with my 50W Accucell 6. I suspect it'll take a little longer to balance charge vs 1 at a time due to more cells to balance at once but so far I am WAY happy with this cable.Very well built and allows you to balance charge batteries that have a large difference in voltage, unlike parallel chargers (which cost me a couple of 3S batteries to discover on my own, yeah, stupid me!). The caveat is that the more difference in voltage between the two 3S packs, the longer balancing takes. And if the difference is enough then it can take longer to charge the two packs together than if done separately. But it is safe to do without destroying the packs if you are balance charging them.
If you do a quick charge or a regular charge without balancing, too big of a voltage difference will overcharge one pack and undercharge the other, potentially destroying the overcharged pack (and if it explodes it'll likely take the other pack with it). Only do this if both packs are close to one another!The easy way to charge multiple 3S batteries with an IMAX B6. Basically halves the charge time. Just set the charger for whatever mA you would normally use for a single battery, but then set it to charge a 6S battery.Works great with my two 2.2Ah nanotechs. I wish it had bullet connectors instead of the xt-60 plug though.works like i expected it to work.great product , now i can charge more than one at a timeFantastic item, I use it all the time in all places and electronics. Nice n shiny finish, good coveringGreat accessory to charge 2x 3S lipos at the same time! Just connect the 2 lipos with the balance plug to the accessory and connect the XT60 plug plus 6S balance plug to your charger!
Bad solder job download now [1269kb] Bad solder job download now [1269kb] Accucel 6 Deans download now [84kb] Instructions download now [1191kb] Thunder AC6 Banana Plug download now [532kb] DadNotGrownUpYet download now [290kb] Twin pack charge lead download now [1718kb] Twin Adaptor Datasheet download now [836kb]