XK3650-10500KV Sensored Brushless Inrunner
Max Amps: 80A
Max Volt: 7.4V
Rpm/V: 10500kv (3.5T)
Resistance: 0.0034 ohms
No-load Current: 9.5A(7.4V)
Dimension: 35.8mm x 52.5mm
Mounting hole depth: 4mm
Length of extend Shaft: 15mm
Shaft diameter: 3.175mm
Max Currents (A)
Length B (mm):
Can Length D(mm)
Unit Weight (g):
Total Length E(mm)
Ran with Nanotech 3s battery, Heatsink Fan on motor. I ran 48 pitch gears 21T Pinion to 64T Spur, and I believe my diff ratio is roughly 2:1.
Just want to make 1 thing clear, I don't do track racing so don't know how it would handle with short course. However it ran the 3 s fine, motor didn't heat up too much, ESC did get a little hot i'll need to upgrade the fan on that using a SkyRC Toro 120A Sensored ESC.
Amazing speed and acceleration though, ripped my tyres to shreads lol only had cheap rubber 1s, probably would need a clay compound tyre.
Overall Extremely fast 116,000 RPM hard to control but super quick!
I'll post some videos shortly!!very sell made, high quality motor.
Very nice motor nice build quality and fits nicely on the Tamiya TA06 chassis but i found that soldering part a bit tedious if don't have the right equipment.
And it does NOT come with a sensor wire so make sure you get one with it if you don't have one already.
comes in a simple white box no instructions.It's a fast motor , not incredibly too much powerful but indeed high rpm .Gets warm quickly so you should double check your set-up . I bought two of them.I like the motor very much, very powerful combo paired with hobby king 100amp esc, and tuned with hobby king 150amp programming card. I have purchase 2 of the 10500kv motor before which was at $20 but this time they hv increase the price....Wat happen HK?Damn... This thing is sweet. Stays cool even with the higher gearing. I use this with the HK100 amp esc and a 5000mah battery pack. Running in a Schumacher Mi4cx Chassis. Pinion is 21t and Spur 85t. Easily 100km/h and doesn't even get hot. Looking to up the timing and go even quicker.Very powerful and fast motor. Put it on a old duratrax evader with a HK120A ESC. Blew the trasmission up at the firs acceleration. Replaced it with a metal one and now it's hard not to do wheelies.125 kph by the way.. Awesom!I got this very fast motor. I use they in my on road car with Turnigy TrackStar 100A and 2S LiPo. The motor is warm and the ESC stays cool to the touch.
This motor not for offroad car, there's a big load and motor is overheating.
With this motor my on road car run up to 100 km/h. It is cool!