This kit is plug-n-fly ready right out of the box. Just take 2 minutes to attach the fins and include your own battery and rx.
Being a flying wing it's very durable and is a great way to learn high-speed flight plus it's small enough to hide in the boot of your family car for those dull holidays!The Ziggy Mini-Wing is a great way to enjoy no-fuss high speed R/C flying.Specs:
Motor: 1806N (2100kv)ESC: 12A
4 Channel R/C system
11.1V 1500mAh 3S1P LiPly battery
Foam safe glue
I like this plane. I did some modification. Instead of the two rudder fins I innstalled drag rudder on each wing tip like the B2 bomber, elevons and a slightly bigger motor. I use 2200 mah 3 cell battery. Flying time is aprox 30 min. The speed regime is good, from realy slow to faster than most of the small war birds.easy to assemble, no instructions about the cog, and if you use the 1500 mha battery it will fly tail heavy as i maiden it today, luckily i did manage to bring it down but in the last moment it dropped nose down from about 5 meters, no damage to the plane at all (tall grass) .comprei essa como minha primeira asa. muito resistente e facil de voar, usei ela em vrias condies: trmicas, colinas, praias...
Pea um experiente pra fazer o primeiro voo. Reaperte todos os perafusos, e divirta-se!
Indico a todos!Bought this and a bonsai wing at the same time , that way the postage cost didnt hurt so much . No damage, packed well. It is actually an " aoxan" wing not ziggi . I used 5 minute epoxy to glue in the stabs. There is plenty of room for reciever,and turnigy 3 cell . Installed a sattelite reciever into mine . it is a tough little wing , you have to crash it pretty hard to damage it . I flew it today ,stock set up with a turnigy 1600 mah 3 cell ,found i had to add about 8 to 10 gram of weight into the nose to get cg perfect for me . 2 clicks of up trim ,i hand launched ,easy as ...and it flew really well ,infact so well that it surprised me !.
1 or 2 clicks left trim and it was perfect , no problem going vertical ,tho not unlimited. roll rate is pretty good also .it is quite fast with stock set up .and seems happy cruising at half throttle or less . it glides well with no power as well ,wings can have wing stall problems and i was mindfull of this but didnt really observe any problems . brought her down and tried a tunigy 1800mah .found that i had to remove the weight i had in the nose and it was a little more difficult to launch and it seemed a lot less stable in the air , so for me the 1600 is the go . the servo control rods bend under load this will become a problem if you want to up grade for more speed and stiffening these i suspect will also improve roll rate ..i like it @ gNice small and almost ready to fly. Remember only that it is very sesitve. To make it less sensitive I need to move push rods to top side of wing and change aileron horns to bigger ones.ow quality.
no instruction manual.
no information on the adjustments on the regulator
no information on air adjustments.
flight is not good.
the glue that was supplied with the kit was unmarked and not usable
fins results were slightly curved and not straight
We bought a pair of these wings. Both arrived packaged together, one with a crush distortion to wingtip trailing edge and elevon. Perhaps the packing arrangement could be improved. The other problem is a complete absence of information as to recommended C of G.
They look good, and promise lots of fun. Just arrived today, and we hope to fly them before the day is through.This plane flies great out of the box; if you get the CG right! Set the CG at the servo wires channel and you will have a rewarding flight. I use 3S 1000mah battery and use lead ballast on the nose. This gives a good 10 minutes of flying. I have tried bigger batteries in lieu of ballast but you need too much weight in the battery bay to get the CG right and the extra weight negatively impacts the flight characteristics. I was a bit put off by the postage cost almost equalling the plane's price but it is still very good value.very eazy, fun, slow, fast.........
runtime is long...
but.. very heavy ^^Great littler flyer, got mine from a friend who orderd two, flying in no time, if you run out of prop saver rings the harware shop No 10 "O" ring for swivel taps is perfect. teaches me to fly my Fun jet better. Would definately buy another.