UBlox LEA-6H Módulo GPS w / Built-in antena Precisão 2.5m

• Overall
• Quality
• Value

Customer Rated

Jun 25, 2013

I bought this to replace the ublox neo 6m currently using with my APM2.5 since i read every where this is perfect match for the APM2.5.
This module come with usb socket so we don't need FTDI cable to write this 3DR-Ublox.txt. setting to the module.
After testing i found out that this module have faster gps lock, (cold start, first time power on) about 3 minutes compare to the neo 6m about 6-7minutes.
Other then having faster cold start and usb ready, i don't feel any improvement to the accuracy or performance comparing to the neo 6m.
4 star for the value since it cost 2 times then the neo 6m but have more or less the same accuracy.

• Overall
• Quality
• Value

Certified Buyer Rated

Jun 20, 2013

Good GPS module. Nice to see HK stocking more parts for the ArduPilot 2.5 clone. Speed and ultrasound sensors next please.

• Overall
• Quality
• Value

Certified Buyer Rated

Jun 14, 2013

This thing locks in almost right away. I'm very happy with the speed of finding sats, even in side my house I've got about a 10 m accuracy! Very Happy!

• Overall
• Quality
• Value

Customer Rated

May 14, 2013

Again another poorly matched peace of gea from hk. a hextronick gps that does not plug into a hextronick flight board recommended by hobby-king to match.
1. does not plug in as connectors are different sizes
2. cant solder it as power pins don't go anywhere on the board.
why supply grnd and 5v pads on a board if they not in the actual circuit. And again no manual on how to work around this stupidity can be found anywhere - that the T hack does not work for peoples info.. Plus this was the board I purchased but mine look different!

only way is to power vir usp at 3v - how stupid.

• Overall
• Quality
• Value

Customer Rated

May 01, 2013

Im very unimpressed about the GPS. First I connect the GPS to the USB port, an it seems to work fine. Next I try to connect to the CRIUS board, but it seems the GPS get no power. I tryed different ways, also to power the GPS from the 5V Pins from the ESC pins but the GPS get no power. After this I measured the 5V input to the ground on the upside of the board, and it looks like, there is no connection from the 5V to the board.
So now I will try to get 5V over the USB port and the signal over the SMD and hope this will work. But that could not be the right way it should work :-(

• Overall
• Quality
• Value

Customer Rated

Apr 15, 2013

I just received my module. The antenna is fixed wrong position. ( see files) I check functionality with u-center software. I got 8 satellities in 2-3 second each time. but accuracy is not as good as 2.5 m as now. I see more than 5 mm in deviation map at u-center software.