Looking for something REALLY different for your 3D foamie?
Check out our single axis thrust vectoring motor mount for small outrunners! It can be set up to augment yaw when mounted horizontally or pitch when mounted vertically.
The mount is simply fitted between the firewall and the motor, supplied with the mount are the pull-pull cables and extended servo arm.
This kit includes a 2206-1500Kv brushless outrunner and o-ring style prop adapter.
Installation is very straightforward!
Motor to mount hole spacing: 32mm diagonal
Firewall hole spacing: 32mm diagonal
Standoff from firewall: 16.5mm
Dimensions: 28 x 15mm
No-load current: 1.0A @ 11.1v
Max Current: 10A
Max Watts: 95W
Mounting Holes: 32mm
Similar to Sunnysky 2206-1500 or the same.
Tested with 3S 860mAh and GWS 8x4.3SF: 11V 12,2A 134W 580g
Tested with 2S 850mAh and GWS 9x5HD: 7,7V 9,6A 74W 460g
After both Tests it was a Little too hot to touch.Positive: The motor is excellent for my Twisted Hobby Pits. At TH they charge $30 for an equavelant unit
Negatives: Motor doesn'y come with bullet connectors. I had to buy 2mm connector kit tocomplete the setup.
The thrust vect motor mount is made of cheezy plastic. It broke at the ball link section while I was screwing onto my plane. I think this motor will sell well without the help of this useless mountGreat setup for 3d.
i always had this issue with this rudder effect is not enough in my 180 grams extra 300.
primary- rudder ,slave - flaps is the mixing i have done....with up rate and downrate change for different mixes i can roll it like a fan and also awesome knife edge with other mix