The all new Turnigy FHSS 2.4GHz transmitter module allows you to bind any trainer port enabled transmitter* with your FBL100 helicopter or Q-Bot Micro quadcopter. It works by using the trainer port's PPM signal from your transmitter.
Simply plug this module into your trainer port, select the signal type (F/J/W) and your then ready to bind with your FBL100 or Q-Bot micro. It's that simple!
The Turnigy transmitter module includes an in-built 3.7V rechargeable lipoly battery for power but can also be powered from your transmitter's charge port when connected with the supplied power cable. If using the in-built battery, it can be easily recharged by the included USB cable.
• Compatible with any trainer port enabled transmitter*
• In-built 3.7V lipoly battery
• Capable of being powered from transmitter's charge jack
Sealed Battery Specification: 3.7V Lipoly 120mAh
Operating Voltage: 5~12V DC
Operating Current: <100mA
Operating Frequency: 2402MHz~2477MHz
Spread Spectrum Mode: FHSS
Number of Frequency Channels: 20
Hopping Rate: 240 jump/s
*Note: Compatible transmitter must output PPM signal via the trainer port.
For whatever reason this stopped working with my JR transmitter but decided it wanted to work just fine on my 9XR. I've had 3 of these now so I know perfectly well how they work and how to properly use them. 2 of them were defective so I don't know about these things. They are very wonky and more than half the time don't work. Also, my recent one came only with trainer cables and no cable to plug into the 12V power supply on the transmitter. This I'm sure is for a very good reason. Previously, when I had the power connector running off my JR, it would constantly blow the radios internal fuse, every single time. I think someone at HK realized this so stopped making it with the power cable. Instead of using the hopeless built in battery, I simply made a hardwired plug to the back of the 9XR's module port. If you would like to know how to do this, feel free to contact me.Otimo produto! Recomendo a compra!!This little device is a life saver for me. When you carefully follow the instructions that comes with and do a few finer tweaks like give it a bit less pitch so that it doesn't drag the motor down too much and start to spin the tail, my FBL100 did not know what hit it. This is how the factory should have setup the transmitter that come with. My setup a FBL100 better than a mcpblablabla, WFT09 WFly Transmitter with a round S-video like cable which I took from my Simulator cables. Thank you hobbyking now please launch the Bind and FLy FBL100 in a small inexpensive box to save costs, awesome.
theuns WFly WFT09 download now [2010kb] dinislam101: JR modle mod download now [3087kb] dinislam101: JR module mod 2 download now [2760kb] Turnigy FHSS Module Manual download now [1543kb]