Diatone Beta110 H4 V1.0 CF Frame Kit
This Diatone Beta V1.0 100mm wheelbase frame is so easy to build it will have you flying in no time. Yet the frame is still a strong build of 1mm carbon fiber.
Added to the kit is a few extra bits and pieces just in case you lose a grommet or two.
Get buzzing around the yard or park.
• Small wheelbase 110
• Tough 1mm carbon fiber frame
• Up to 60mm propellers
• Rubber motor mounts to ease vibration
• Easy build
Motor Diameter: 8.5mm
Dimensions: 97 x 85 x 18mm
Bare Weight: 8.4g
1 x Diatone BETA110 V1.0 Frame Kit
1 x 250~950mAh 1S LiPoly Battery
4 x 8mm motors
4 x 55~60mm propellers (CW, CCW)
1 x Flight Controller (recommended Quanum Pico)
4 x ESC’s (not needed if using Quanum Pico FC)
1 x 5-6 channel RX/TX
1 x FPV package (optional)
This is a GREAT little frame! Priced right as well. I use it with the Nano QX flight controller (brick), 8.5mm motors, Ladybird props, 600mah nanotech 1S batt, and Quanum Elite 25mw Cam/VTx combo and it is a great little FPV quad. Could use 300mah batt and make it lighter, but 600 gives 5plus min flight times.The bottom plate was cut from a (B- Quality) plate that was warped, as a result the frame is not flat and the motors cannot be mounted symmetrically which gives uneven thrust.
Correcting this is impossible as the fibers were probably baked under tension.
Complete garbage, do not recommend it!
This is a pretty fun little frame. Took moments to assemble, and using a pico FC minutes to set up. It flies nicely, it seems strong enough for its size and weight. So far so good.