This is a very handy little device that is used to sequence the landing gear doors and landing gear both during extension and retraction.
With the use of spitter leads you are able to sequence an entire gear and door system on many models that require correct sequencing from just one of these units and from a single channel on your reciever.
There are two selectable sequence types and there is an instruction leaflet included.
Voltage range: 4.8-6.0v
*Color may vary
Works great. It can only work in one mode, type 1 or type 2 (see manual). When the plane has both 2 types of landing gear, you need 2 of these sequencers, one for the front gear and one for both the wing gears.Great product simple to install works a treat for my scale glidersGood quality sequencer with reasonable delays - light weight and super easy programming - has standard programming for mustang style doors so a good easy install itemA perfect and easy to handle piece! Next time i buy more of this. Only one swith on my transmitter and the gears and doors work like they should.it is a great addition to the bird, very easy to install and set, no issues, no hassle. very cheap even less than a piece of gum
Great addition to the bird, no hassle or problems in the installation and the setting is even easer, worked right out of the box.A good little unit at a great price. You can select whether or not gear door stays open while gear is down or it closes between cycles. I have three and all work flawlessly.These work great for the price. I do however keep some spare just in case, but haven't had one fail yet.Very good product! Nice! Perfect!Fixed delay time between the sequence but it works as expected. What would make it better is the ability to reverse the channels. This will help when a door servo or LG works opposite to the expected direction, avoids having to stick a SFO reverse on the output channel.