When it comes to putting rounds down range, no one wants to compromise on fire power! thats why the legendary Turnigy nano-tech batteries are now available for Airsoft combat. Higher motor RPM, less voltage sag and extended operating times equal better performance from your weapon of choice.
The nano-tech Airsoft series also feature 5C charge ratings putting you back on the front line faster!
Get an unfair advantage and make sure your opponents know that they have been taken out by nano-tech!
Voltage: 3S1P / 3S Cell / 11.1V
Discharge: 15C Constant / 25C Burst
Weight: 115g (including wire, plug & case)
Dimensions: 128x7x20mm (Each)
Balance Plug: JST-XH
Discharge Plug: Mini-Tamiya (Mini Molex)
The nano-core technology in lithium ion batteries is the application of nanometer conductive additives.
1) The nanometer conductive additives form ultrastrong electron-conducting networks in the electrodes which can increase electronic conductivity. 2) These additives create a superstrong ability for imbibition in the carrier liquid to supply more ion channels. This improves the ability of ion transmission and ion diffusion. Through improving electronic conductivity and ion transmission, the impedance is reduced and the polarization of high rate discharge decreases greatly.
Advantages over traditional Lipo batteries:
-Power density reaches 7.5 kw/kg.
-Less Voltage sag during high rate discharge, giving more power under load.
-Internal impedance can reach as low as 1.2mΩ compared to that of 3mΩ of a standard Lipoly.
-Greater thermal control, pack usually doesnt exceed 60degC
-Thickness swelling during heavy load doesnt exceed 5%, compared to 15% of a normal Lipoly during heavy load.
-Higher capacity during heavy discharge. More than 90% at 100% C rate.
-Fast charge capable, up to 15C on some batteries.
-Longer Cycle Life, almost double that of standard lipoly technology.
*The length of balance charging wire may vary
Unit Weight (g):
Max Charge Rate(C):
better stock up, can't go anywhere without this.These fit perfectly in the ASG Scorpion. Just make sure you keep the Tamiya plug straight or the front end will be fursnickety going back together. I have ran 4 full hi caps through and the battery was still firing fast and hot.These fit perfectly in the ASG Scorpion. Just make sure you keep the Tamiya plug straight or the front end will be fursnickety going back together. I have ran 4 full hi caps through and the battery was still firing fast and hot.ottimi di buona qualita plusplusplusplus plusplusplusplus plusplusplusplus plusplusplus plusbest lippo for my airsoftgun..(continued)
for tight fitting AEGs. To date, the most extreme setup I have is inside my PDW's rail (After much, MUCH modification) so almost anything is possible. If one had the time you could easily cut and dremmel material to fit inside any rail system. In said PDW, I've ran it 25-30RPS at 360FPS no problem, however I'm currently finishing a DSG build that includes a riot spacer'd SP150 and Lonex titan A2. These should put me at 40-50RPS @ 400FPS if all goes well. I will post another review to see how this little pack handles that setup! Overall, HIGHLY recommend pack!Quite the little punch from such a small lipo. I ordered both this, and the 1200mah version of this 3s lipo. The only major difference is a VERY slight, and almost unnoticeable thickness difference. I would opt for this lipo.
Uses: Light-moderate upgraded AEGs. If your smart you'd use this lipo in an efficient setup. This rips when paired with a decent AEG, but SHINES when used with a fine tuned gun. This being a lipo, I'd recommend, as I always do when it comes to airsoft replicas and lipos, to invest in a Mosfet. The best mosfet units are actually the hand made ones by people whom know what they are doing, at the time of this review I recommend any unit using the IR3034.
Fitment: Yes, this fits perfectly in Crane stocks. Two cells on one side, and another on the other. There is ample wire, so when you do change the connector to Deans or TX60, I'd recommend shortening the wires. That is preference however. I've also had success fitting these in pretty much every AEG I've tried it with. That includes all types of G36, M4s, Mp5s, etc etc. Very versatile battery pack.
Performance: With an average AEG with an M120 expect solid 20-25RPS, depending on your setup. A tuned AEG can push 30 it all depends on your setup. Being a tech for 6 years I am very confident that this pack can and will meet your needs and expectations.
Extra notes: I personally use this as my go to packWhat a battery! I really like this in the dboys CASV. They are very slim and able to slip between the barrel and side rails with the middle pack laying flat. Combine this battery with the SHS long torque motor, 120 factory spring and it is a hoss!Fits Masada handguards! I know many who own this gun are having problems finding a battery that fits. This one fits fine!i have 2 of these and just ordered 2 more they will fit the m4 handguard and in a crane stock (1 in the buffer tube,, 1 down each side) they work great ,, the lipo alarm does beep on semi from time to time but doesnt stay on even with a fresh charge ,, i have played for 5 hours shooting over 5000 rounds and the green lights on lipo monitor were still on